Service manual

EElleeccttrroonniicc CCoonnttrrooll
3-2
CCoonnttrrooll PPaanneell ((UUsseerr IInntteerrffaaccee LLaayyoouutt)) WWaavvee--TToouucchh™™
SSeelleeccttiinngg tthhee AApppprroopprriiaattee CCyyccllee aanndd SSeettttiinnggss OOvveerrvviieeww
Turn the cycle selector knob in either direction to select the cycle desired. The icon for that cycle will be
illuminated and if the cycle description feature is turned on, the cycle and estimated cycle time are
displayed on the User Interface screen for 5 seconds. Press any key to advance the User Interface to
select settings and options.
Press any key or the User Interface screen will automatically advance after 5 seconds and display the
preset drying temperature, dryness level (Auto Dry) or drying time (Time Dry), extended tumble time, and
options for the cycle selected will be displayed.
To change the settings, press the temp, dryness level (Auto Dry) or drying time (Time Dry) and extended
tumble buttons to scroll to the desired settings. Press the scroll up or scroll down buttons under options
to scroll through the options menu. Press the select button to add or delete options. The estimated cycle
time will be displayed at the top of the screens.
Adjustments to a cycle will be remembered and recalled each time that cycle is selected in the future. To
return to the factory default settings, select RESET in set prefs under the options scroll buttons.
Demo Mode
Demo Mode will standby for 10 minutes then perform an LED on/off sequence for 3 minutes. During the
standby sequence the drum light and start button will be activated. The controls will be fully functional
during Demo Mode with abbreviated cycles lasting about 1 minute. Some features will be deactivated
during Demo Mode for safety purposes. When the units are in Demo Mode the text “DEMO MODE” will
be displayed in the LCD screen. Demo mode will be saved if the units are unplugged or if there is a
power outage. To deactivate Demo Mode repeat steps 1-3 below.
NOTE: Set the controls to the desired language in the SET PREFS menu. After the unit has been set to
DEMO mode the language can not be changed.
1. Turn the cycle selector knob to TIME DRY cycle, press the START button then the CANCEL button.
2. Activate the controls by turning the cycle selector knob and turn to TIME DRY cycle.
3. Press and hold CANCEL button and EXTENDED TUMBLE (Third button from the left) for 3 seconds.
4. DEMO MODE instructions have to be completed by 7 seconds of the control activation.
5. Press the CANCEL button to begin DEMO MODE.
6. To deactivate DEMO MODE repeat steps 1 – 3.
FFiigguurree 33--11.. WWaavvee--TToouucchh™™ CCoonnttrrooll PPaanneell
Cycle Selector
Dryness Level
Temperature Extended Tumble
Options Scroll
User Interface
Display