User manual

The safety equipment
5
The safety equipment
There should be at least 40 cm of worktops on both sides
of the cooker
( SEE PICTURE ) . Alternatively the cooker can be
installed with a wall or a tall kitchen unit on one side and
a worktop on the other.
Child safety is further improved if the following
equipment is fitted/in use:
Non-tip device
The non-tip device should be fitted, to prevent the
cooker from tipping if subjected to an abnormal
loading. The non-tip device can only provide pro-
tection when the cooker is pushed into its normal
position.
Before fitting the non-tip device, make sure the cooker has
been levelled and adjusted to the correct plinth height (see
“Installation” on p. 23).
1 Draw a line on the wall – after levelling the
cooker – along the top edge of the hob (see illus-
tration).
2 The measurements shown can be applied
whether the non-tip device is fitted on the left or
the right (see illustration). Measure and mark
where the non-tip device is to be placed, then
screw it onto a solid material or a suitable rein-
forcement or fixings.
NOTE ! If the space between kitchen units is wider than
the cooker, you will need to alter the measurements
shown in the illustration if the cooker is to be centred.
3 If you alter the measurements, remember to
align the cooker correctly when pushing it into
place, so that the non-tip device enters the hole
on the cooker rear.
The hob guard (optional accessory)
The hob guard should be fitted to make it harder
for children to reach pans on the hob.
1
Press the plugs into the front holes.
2 Place the guard on the cooker with the plugs over the
edge of the hob.
3 Angle the guard downwards and then back upwards
so the edges on its two sides engage under the edge
of the hob.
4 Lock it in place with the rear plugs.
min. 40 cm
min. 40 cm
55-60 mm
35-65 mm
2
3
1
4
5