User manual

To measure how far the food is cooked.
•
Removable telescopic runners
To put shelves or trays on them.
4. BEFORE FIRST USE
WARNING!
Refer to the Safety chapters.
4.1 Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Refer to chapter "Care and Clean-
ing".
4.2 Sensor field
Touch and hold for minimum 1
second the sensor field on the
control panel to operate the appli-
ance.
1s
4.3 Setting the time
The oven only operates after time
set.
When you connect the appliance to the
electrical supply or in case of a power cut,
the Time function indicator flashes auto-
matically.
To set the current time use
or but-
ton.
After approximately 5 seconds, the flash-
ing stops and the display shows the time
of day set.
You can only change the Time
of day
if :
• the switch-on lock is not on
• none of the clock functions Du-
ration
or End is set
• no oven function is set.
4.4 Pre-heating
1.
Set function and maximum tem-
perature.
2.
Let the appliance operate without the
food for approximately 1 hour.
3.
Set function and maximum tem-
perature.
4.
Let the appliance operate without the
food for approximately 10 minutes.
5.
Set function and maximum tem-
perature.
6.
Let the appliance operate without the
food for approximately 10 minutes.
This is to burn off the residue in the appli-
ance. The accessories can become more
hot than usually. When you pre-heat the
appliance for the first time, the appliance
can make an odour and smoke. This is
the usual effect. Make sure the airflow is
sufficient.
Preheat the two ovens. Heat up one oven
at a time.
5. HOB - DAILY USE
WARNING!
Refer to the Safety chapters.
8
www.electrolux.com