User manual

electrolux
10
Wipe the oven over with a soft cloth soaked
in warm soapy water after each use. From
time to time it will be necessary to do a
more thorough cleaning, using a proprietary
oven cleaner.
The Hob Top
The hob is best cleaned whilst it is still
warm; as spillage can be removed more
easily than if it is left to cool.
Regularly wipe over the hob top using a soft
cloth well wrung out in warm water to which
a little washing up liquid has been added.
Avoid the use of the following:
• household detergent and bleaches;
• impregnated pads unsuitable for non-
stick saucepans;
• steel wool pads;
• Bath/sink stains remover.
Should the hob top become heavily soiled, it
is recommended that a cleaning product
such as Hob Brite or Bar Keepers Friend is
used.
The Hotplates
Spills onto the actual plate should be
removed using warm water and a soft
brush, nylon or plastic scourer. To keep the
plates looking as new, hotplate conditioner
can be purchased from most hardware
stores, e.g. “4 Hob” by Home Care
Products (follow the manufacturer’s
instruction for use).
Alternatively, wipe the plates with a drop of
olive oil on a kitchen towel to avoid rust. It is
important to note that the plate will smoke a
little and produce a slightly unpleasant odour
when next used.
Drying
Important: After cleaning, dry the hotplates
throughly by switching on to a low-medium
setting for a few minutes.
Restoring
To maintain the appearance of your sealed
hotplates apply a little salt-free vegetable oil
or restorative agent (i.e. :”Collo Electrol”, or
Minky Hotplate Cleaning Cloths) periodically.
Cleaning the oven door
Removing oven door from its hinges
To make it easier to clean the oven, the
oven door can be removed.
Open the oven door into the horizontal
position. Then lift up the clips on the two
door hinges as far as they will go (a).
Slowly close the door again as far as the
stop and lift the door until the hinges come
out (b).
Replacing the oven door on its hinges
When putting the door back on its hinges,
reverse the procedure for removing the door
from its hinges.
Re-insert the door’s hinges into the slots (c).
When you do this, make sure the hinges
engage properly and evenly.
Then slowly lower the door downwards.
When you do this, make sure the corners of
the door do not touch the bottom of the
frame (if this happens, lift the door up again
and realign the hinges).