User manual

38
Alternatively you could remove the
floor covering. This appliance is
heavy and care must be taken when
moving it. Do not try to move the
appliance by pulling the door
handles.
To move the appliance, open the
grill door. Raise the appliance off its
front feet by lifting it from inside the
oven. Pull the appliance forward.
When you replace the appliance
push it back to the stop and make
sure there is the same gap at each
rear corner.
For your safety
Do not try to disconnect the
appliance from the gas supply if the
supply pipe does not have a bayonet
connection, as described in the
installation instructions. If this is the
case contact the person who
installed the appliance.
Location of appliance
This appliance must not be installed
in a bed-sitting room of volume less
than 20m
3
or in a bathroom, shower
room or garage. It is essential that
the appliance is positioned as Fig
1a. Shelves, wall cabinets and
cooker hoods must be fitted a
minimum of 787mm directly above
the top of the hotplate (or greater for
cooker hoods if recommended by
manufacturers instructions) and
400mm above the hotplate when
fitted in line with the outside of the
appliance.
If the units are intended to be fitted
adjacent to the appliance but less
than 400mm above the hotplate,
then a minimum space of 100mm
must be maintained between the
sides of the unit and the appliance
(See Fig 1b).
Fig 1.a
Fi
g 1.b