User manual

Installing the door and the glass panel
When the cleaning is completed, install
the glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the
inner side of the door. Make sure that af-
ter the installation the surface of the glass
panel frame on the screen-printing zones
is not rough when you touch it.
Make sure that you install the internal
glass panel in the seats correctly. Refer to
the illustration.
11.3 Oven lamp
WARNING!
Be careful when you change the
oven lamp. Always switch off the
appliance before you start to re-
place the lamp. There is a risk of
electric shock.
WARNING!
Bulb lamps used in this appliance
are special lamps for use only in
household appliances. Do not use
them to illuminate household
rooms or parts of rooms. If you
need to replace a lamp, the re-
placement lamp must have the
same power and be for use only
in household appliances.
Before you change the oven lamp:
Deactivate the appliance.
Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the oven.
This prevents from damage to the oven
light and glass cover.
Replacing the oven lamp:
1.
Find the lamp glass cover at the back
of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2.
Clean the glass cover.
3.
Replace the oven lamp with an appli-
cable 300 °C heat-resistant oven
lamp.
Use only the same oven lamp type as
the replacement lamp. It must have
the same power and be for use only
in household appliances.
4.
Install the glass cover.
12. WHAT TO DO IF…
Problem Possible cause Remedy
There is no spark
when lighting the gas
There is no electrical
supply
Make sure that the unit is con-
nected and the electrical supply
is switched on.
There is no spark
when lighting the gas
There is no electrical
supply
Examine the house electrical in-
stallation fuse.
There is no spark
when lighting the gas
Burner cap and
crown are placed un-
even
Make sure that the burner cap
and crown are in correct posi-
tions.
ENGLISH 19