User manual

WARNING!
Before replacing the injectors,
make sure that the gas knobs are
in the Off position and disconnect
the appliance from the electrical
supply. Let the appliance cool off
fully. There is a risk of injury.
13.6 Injectors replacement
Replace the nozzles when changing the
gas type.
1.
Remove the pan supports.
2.
Remove the caps and crowns of the
burner.
3.
With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use.
4.
To assemble the parts, do the same
steps in reverse.
5.
Replace the rating label (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find
this label in the package supplied with
the appliance.
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure ad-
juster on the gas supply pipe.
13.7 Adjustment of minimum
level
To adjust the minimum level of the burn-
ers:
1.
Light the burner.
2.
Turn the knob on the minimum posi-
tion.
3.
Remove the knob.
4.
With a thin screwdriver, adjust the by-
pass screw position (A). The bypass
screw position (A) depends on model.
A
• If you change from natural gas to liquid
gas, fully tighten the adjustment screw
in.
• If you change from liquid gas to natural
gas, undo the by-pass screw approxi-
mately 1/4 of a turn.
WARNING!
Make sure the flame does not go
out when you quickly turn the
knob from the maximum position
to the minimum position.
13.8 Oven injector replacement
AB
1.
Remove the bottom plate of the oven
cavity (A) to get access to the oven
burner (B).
ENGLISH 23