User's Manual

Maintenance electrolux 15
EN
Replacing the Charcoal Filter
This fi lter cannot be washed or regene-
rated, and must be replaced when the F
touch control starts to fl ash, or at least
once every 4 months. The alarm is only
triggered when the motor is on.
Enabling/Disabling the alarm signal
• In Recirculation Version Hoods, the
Filter saturation Alarm must be ena-
bled at the time of installation or later.
• Switch off the lights and the motor.
• Disconnect the mains power supply
to the hood by removing the motor
unit power supply cable connector,
switching off the power supply at the
Mains or turning the Main switch off.
• Restore the connection, pressing and
holding T2.
• Release the touch control, touch
controls L, T2 and F will light up nor-
mally.
• Within 3 seconds press the touch
control F until the key itself fl ashes to
confi rm as follows:
• 2 fl ashes – Charcoal Filter saturation
Alarm ENABLED
• 1 fl ash - Charcoal Filter saturation
Alarm DISABLED
Reset the alarm signal
• Stop the motor.
• Press the touch control F for at least
4 seconds, until the touch control T1
fl ashes.
Replace the Filter
• Pull the Comfort Panel to open it.
• Remove the metal grease fi lters.
• Remove the saturated charcoal fi lter,
turning the fasteners provided.
• Fit the new fi lter and fasten it its cor-
rect position.
• Put the metal grease fi lters in their
seats.
• Close the comfort panel.
Light replacement
20 W halogen light.
• Remove the snap-on lamp cover by
levering it from under the metal ring,
supporting it with one hand.
• Remove the halogen lamp from the
lamp holder by pulling gently.
• Replace the lamp with a new one of
the same type, making sure that you
insert the two pins properly into the
housings on the lamp holder.
• Replace the snap-on lamp cover.