Technical data

Fig. C Control Panel - RM4291
Fitted Equipment
240V Operation
1. Turn off gas or 12V operation when
applicable.
2. Turn the knob (C) of the thermostat to its
highest (coldest) position.
3. Set switch (B) to position I. The switch will
light up green when the power supply is
connected.
12V Operation
Only operate your refrigerator on 12V when
the engine of your vehicle is running. Install
through a relay, otherwise your battery will
soon be discharged.
Note: Before operating the refrigerator on
12V, it should be pre-cooled, together with its
contents, by running it on bottled gas or
240V for a few hours before changing over to
12V and starting on a journey.
1. If applicable turn off the gas operation.
2. Set the 12V rocker switch (A) to I. The
switch will light up red when the power
supply is connected.
REGULATING THE TEMPERATURE
The position numbers refer to Fig. B.
Once the refrigerator has been started it will
take a few hours to become cold.
On 240V operation the refrigerator is
controlled by a thermostat and the
thermostat knob (C) should be set at 3-5. If a
MODEL RM4291 (86 litres)
Two rocker switches are used to select the
electric power supply, one for 12V (A) and
one for 240V (B) (see Fig. C).
Refrigerator temperature is controlled by a
thermostat knob (C) when the refrigerator
runs on 240V.
The refrigerator runs continuously on 12V
operation (no thermostat).
The gas supply is turned ON/OFF by means
of the knob (D). When lighting the gas, the
knob must be pressed as explained in LP
Gas Operation.
Refrigerator temperature is controlled by a
thermostat (D) when the refrigerator runs on
LP gas.
lower (colder) temperature is desired, set the
thermostat to a higher figure.
On LP gas operation the refrigerator
temperataure is regulated by the gas
thermostat knob (E), which should be set at
3-5. If a lower (colder) temperature is desired,
set the thermostat at a higher figure.
On 12V operation the refrigerator works
continuously.
52
C D E
A
B F