Technical data

Fitted Equipment
Toilet Section
The toilet section includes a rotatable bowl,
a removable seat and a control unit with a
flush button and a waste level warning
device. Under the bowl, the valve blade
handle is located.
Preparing for Use
1. To remove holding tank, open the access
door. Pull retaining clip upwards, (fig. 1)
2. Remove holding tank by pulling straight
out. When holding tank hits the stop, tilt
downwards slightly and remove. (fig. 2)
3. Position tank vertically and swivel pour-
out spout upwards. (fig. 3)
4. Remove the cap of pour-out spout. Add
required amount of toilet fluid through
pour-out spout. Add small amount of
water through spout to cover holding
tank bottom. Replace cap and return
pour-out spout to its original stored
position. (fig. 4)
NOTE: Hotter weather or longer
retention time may require additional
toilet fluid. Use only Thetford toilet
fluid to achieve the best results.
CAUTION: Never add toilet fluid
directly into toilet bowl.
5. Slide the holding tank into the vehicle
through access door. (fig. 5)
6. Make sure the holding tank is secured by
the retaining clip. Close and look access
door. (fig. 6)
Operation
7. Turn the bowl in the most comfortable
position, when necessary. (fig. 7)
8. Before using the toilet we recommend to
add some water to the bowl by pressing
the flush button. Flush will stop when the
button is released. (fig. 8)
79
1 2
3 4
5 6
7 8