User manual

10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
An intermittent acoustic signal operates.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, the display
shows a message.
Display Problem
Attention: no intake of water possible. The appliance does not fill with water.
Attention: water is not draining. The appliance does not drain the wa-
ter.
Attention: The anti flood system has
been activated.
The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the check.
Problem Possible solution
You cannot activate the appli-
ance.
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press OK .
If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance does not fill with
water.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain the
water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
The anti-flood device is on. Close the water tap and contact the Service.
When the check is completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other messages, con-
tact the Service.
ENGLISH 17