Installation Instructions

4
Installation Requirements
Tools and materials needed for installation:
Adjustable
pliers
Adjustable
wrench
3/8" or
10 mm
box wrench
OR OR OR AND AND
Ratchet and
socket set
Carpenter’s level
Optional
universal
wrench
Inlet
Hose
(x2)
Shipping Hardware
 Foam shipping support (under wash
tub) removed and stored
 Shipping bolts and spacers removed
from rear of appliance and stored
 Hole plugs (shipped in bag in drum)
installed in holes in backsheet
Leveling
 Washer is level, side-to-side and
front-to-back
 Cabinet is sitting solid on all corners
Water Supply
 Use only new hoses and verify
rubber sealing washers are installed
 HOT supply is connected to HOT
inlet and COLD supply is connected
to COLD inlet
 HOT and COLD water supply
turned on
 No leaks present at water supply
connections or appliance inlet
connections - recheck in 24 hours
Drain
 Stand pipe or wall drain height
minimum 24”
 Verify anti-siphon disc is attached
toward end of drain hose
 Drain hose secured in place with
cable tie (shipped in drum)
Door Reversal
 Follow detailed instructions in
this guide
 Test hinge and latch for function
Electrical Power
 House power turned on
 Washer plugged in
Final Checks
 Installation Instructions and Use
and Care Guide read thoroughly
 Door locks and water enters drum
when cycle starts
 Registration card sent in
Installation Checklist
NOTE
Hoses are not included with washer
purchase. See “Accessories” section for
various inlet hose kits to fit your specific
installation.
Please read and save
this guide
Thank you for choosing Electrolux, the
premium brand in home appliances. These
Installation Instructions are part of our
commitment to customer satisfaction and
product quality throughout the life of your
new appliance.
Questions?
Toll-free telephone and online support:
U.S.
1-877-4ELECTROLUX (1-877-435-3287)
www.electroluxappliances.com
Canada
1-800-265-8352
www.electroluxappliances.ca