Data Sheet

1
Canada 1-800-265-8352
Push Button Cycle Select Dryer User Interface
Rotary Dial Cycle Select Dryer User Interface
A11199902 (1803)
USA 1-877-435-3287
This information is intended for Qualified Technicians Only.
TABLE OF CONTENTS
Entering Diagnostic Mode:
1. Press power and look for console light up.
2. Rotate cycle selector ring (on some models) or repeatedly press
cycle button (on other models) to set cycle to normal.
3. Press the start button.
4. Power off machine by pressing the power button.
5. Power on machine by pressing the power button again.
6. Within 10 seconds, simultaneously hold temp + select (set) but-
tons together for 3 seconds.
7. Diagnostic Mode is active when LED’s start blinking in sequence.
This is the pre-test position “ ”, which tests the lights and buttons.
Safety items throughout this manual are labeled with a WARNING or
CAUTION based on the risk type as described below:
This symbol alerts you to situations that may
cause bodily injury or property damage.
This symbol alerts you to situations that may
cause serious body harm, death or property
damage.
Dryer Tech Data Sheet
Scrolling through Diagnostic Mode tests:
Tests are selected by using the same method to select cycles. See
Diagnostic Mode Tests Table.
To begin, press and hold the cycles button for 2 seconds. The unit
will advance to the first test; and flash “ “ on the display.
Press the cycles button to advance to the following test. Press the
temp button to go back to the previous test. Test sequence numbers
are briefly displayed when each test is selected. The displayed test
numbers also correspond to the selector LEDs to the right of the
numeric display; beginning with the top LED, following downward.
Exiting Diagnostic Mode:
Hold the power key for 3 sec, when not in “ ” test step
Lights/Buttons, or unplug the unit.
www.electroluxappliances.com
CAUTION
WARNING
CAUTION
Unless otherwise directed, disconnect electrical current before
servicing.
Dryer Tech Data Sheet ........................................................................... 1
Diagnostic Mode Tests/Demo Mode ...................................................... 2
Dryer Error Codes .................................................................................. 3
Wiring Diagrams .................................................................................. 10
1
power
2
cycle status display
3
cycle selector
4
temperature
5
dryness (dry level)
6
time dry (dry time)
7
options
8
select (set)
9
cancel
10
start / pause
2 71 63 854 9
10
2 71 63 9854 10