EN FRONT LOAD WASHER USE & CARE GUIDE FR LAVEUSE Á CHARGEMENT FRONTAL GUIDE D’UTILISATION ET D’ENTRETIEN ES LAVADORA DE CARGA FRONTAL GUÍA DE USO Y CUIDADO A11200102 April 2018
Finding Information Please read and save this guide Thank you for choosing Electrolux, our premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction and product quality throughout the service life of your new appliance. Table of contents Finding Information................................ 2 Safety.................................................... 3 Features................................................ 6 Operating Instructions.........................
Safety Important Safety Instructions Safety Precautions Definitions DO NOT attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Danger, Warning, or Caution based on the risk type. This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Safety • DO NOT continue to use the washer if you hear squeaking, grinding, rubbing or other unusual noises. This could be a sign of mechanical breakdown and lead to fire or serious injury. Contact a qualified technician immediately. Protect Children • DO NOT allow children to play on or in the washer. Close supervision of children is necessary when the washer is used near children. As children grow, teach them the proper, safe use of all appliances.
Safety Prevent Injury And Damage To The Washer To prevent serious personal injury and damage to the washer: • All repairs and servicing must be performed by an authorized service technician unless specifically recommended in this Use & Care Guide. Use only authorized factory parts. • DO NOT tamper with controls. • DO NOT install or store the washer where it will be exposed to the weather. • DO NOT install on carpet. Install washer on a solid floor.
Features Laundry Products Dispenser Cycle Selector LED Display Drum Light (select models only) Reversible Door (400/500/600 series models only) Control Lock Door Striker Serial # and Model # Cascading Wash Vanes Door Stand Ventilation Inner glass with small article redistribution ramp Door Latch with Safety Lock Wide-Angle Door Hinge Flexible door Stainless Steel gasket Wash Drum Adjustable Leveling Legs Not all cycles, options, or features listed are available on every model.
Features Model Series 300 SERIES 1 2 3 4 5 6 7 8 9 400 SERIES 1 2 3 4 5 6 7 8 9 10 500 SERIES 1 2 4 5 6 7 8 9 11 10 600 SERIES 1 2 3 4 5 6 7 8 9 11 10 1 power 4 temperature 7 options 10 start 2 LED display 5 soil level 8 set/select ® 11 PODS 3 cycle selector 6 spin speed 9 cancel (select models) This manual covers many models and not all cycles, options, or features listed are available on every model. Consoles shown above for reference only.
Operating Instructions Operating your washer WARNING To reduce the risk of fire, electric shock or injury to persons, read the Important Safety Instructions in this Use & Care Guide before operating your washer. WARNING CAUTION RISK OF INJURY DO NOT wash water resistant and water repellent clothing or other materials. Failure to follow these instructions may result in an abnormal vibrating and outof-balance condition that could result in physical injury, property damage, and/or appliance damage.
Operating Instructions STEPS TIPS IMPORTANT 5. Add wash • Water conditioners, detergent boosters products to and enzyme products may be added with detergent. dispenser. • See Adding Laundry Products for detailed information on the use of the product dispensers. • See Adding Laundry Products for detailed information on the use of various wash products (detergent, bleach, stain treatment, fabric softener, etc). 6.
Operating Instructions Adding Laundry Products Laundry Product Dispensers Product dispenser - three compartment dispenser (300 Series) Detergent Liquid or Powder Liquid Bleach Liquid Fabric Softener Product dispenser - Adaptive Dispenser™ (400, 500, and 600 Series) Detergent Liquid or Powder Detergent Pack Compartment* (500 and 600 Series) Liquid Bleach FP Without Detergent Pack Compartment (400 Series) Stain Soak/Treat O Liquid Fabric Softener *Max.
Operating Instructions 11 Adding Laundry Detergent to the Three Compartment Dispenser Adding Laundry Detergent to the Adaptive Dispenser™ Liquid or Powder Detergent • Use the cap or scoop provided by the detergent to add recommended amount of detergent. • Amount of detergent may need to be adjusted for water temperature, water hardness, load size, and soil level. Follow manufacturers instruction. In a three compartment dispenser use either liquid or powder detergent. DO NOT mix both.
Operating Instructions Detergent Pack For 300 and 400 series models Add detergent pack directly to the empty drum BEFORE placing laundry into the unit. • DO NOT place detergent packs directly into the detergent drawer. The gel coating may cause the detergent drawer to become clogged. For 500 and 600 series models Add the recommended quantity of (one or two) high efficiency detergent packs to the detergent pack compartment in the dispenser. • DO NOT place more than two packs into the dispenser.
Controls and Settings 13 Settings Chart - 300 Series Washer warm cold heavy normal clean washer normal hot rinse & spin heavy duty delicates These temperature, spin speeds, soil levels and options are available with the following cycles: CYCLE SELECTIONS soil light spin high medium no spin CYCLE OPTIONS options extra rinse delay start lock press & hold chime = Avai
Controls and Settings Settings Chart - 400 Series Washer normal delicates 20min fast wash warm cold tap cold heavy normal light extra light clean washer whitest whites hot rinse & spin heavy duty These temperature, spin speeds, soil levels and options are available with the following cycles: CYCLE SELECTIONS soil spin high medium low no spin
Controls and Settings 15 Settings Chart - 500 Series Washer normal activewear colors delicates 18min fast wash clean washer whitest whites rinse & spin heavy duty These temperature, spin speeds, soil levels and options are available with the following cycles: CYCLE SELECTIONS CYCLE SETTINGS sanitize hot warm cold tap cold soil max heavy normal ligh
Controls and Settings Settings Chart - 600 Series Washer normal activewear colors delicates 15min fast wash clean washer whitest whites rinse & spin heavy duty These temperature, spin speeds, soil levels and options are available with the following cycles: CYCLE SELECTIONS CYCLE SETTINGS sanitize hot warm cold tap cold soil solid soil max heav
Controls and Settings 17 Cycle Selection Press the power button to turn on the unit. Then, turn the cycle selector in either direction or press the cycles button (dependent on model) to scroll to the desired cycle. The indicator light for that cycle will be illuminated. The estimated cycle time will appear on the LED display and indicator lights adjacent to the default settings (water temperature, final spin speed, and soil level) will illuminate for the cycle selected.
Controls and Settings To protect your fabrics, not all temperatures are available with every cycle. If a temperature is not appropriate for the cycle, it cannot be selected and will not be lit by pressing the temp button. The temperature selected for the cycle will be remembered and recalled each time that cycle is selected in the future. All wash water temperatures are automatically regulated to maximize detergent effectiveness and improve washing performance.
Controls and Settings 19 Spin Speed Max (on select models), high, medium and low (on some models) spin speeds are available for each cycle. The spin speed and/or duration of final spin vary from model to model and cycle to cycle. Increasing the spin speed will extract more water, decrease drying time and conserve energy. Decreasing the spin speed will reduce wrinkling. Select low spin speed (on some models) to gently spin items that should be line dried.
Controls and Settings IMPORTANT • If steam is selected, rinse temperatures will be elevated. • If the wash cycle is paused or cancelled during a steam cycle, the door will remain locked until it cools. You may manually perform a rinse & spin cycle to cool the internal temperature sooner. • During a steam cycle, steam exiting from the rear vent of the washer is normal and not cause for alarm.
Controls and Settings 21 Eco Indicator The eco symbol will light up on the LED display to indicate that the selected combination of temperature, spin speed and options are eco friendly. Oversuds Protection A situation where oversudsing has been detected by the washer will result in the washer requiring additional rinses until the suds have been cleared. Each extra rinse the washer performs to clear the suds will add approximately 5 minutes to the cycle duration.
Stain Removal Guide Stain Removal Procedures To reduce the risk of fire or serious injury to persons or property, comply with the basic warnings listed below: • Read and comply with all instructions on stain removal products. • Keep stain removal products in their original labeled containers and out of children’s reach. • Thoroughly wash any utensils used. • DO NOT combine stain removal products, especially ammonia and chlorine bleach. Dangerous fumes can result.
Stain Removal Guide 23 Stain Removal Suggestions STAIN Adhesive tape, gum, rubber cement Baby formula, dairy products, egg Beverages (coffee, tea, soda, juice, alcoholic beverages) Blood TREATMENT Apply ice. Scrape off excess. Place stain down on paper towels. Saturate with prewash stain remover or nonflammable dry cleaning fluid. Use product containing enzymes to pretreat or soak stains. Soak for 30 minutes or more. Wash. Pretreat stain. Wash using cold water and bleach safe for fabric.
Care & Cleaning Inside Routine Cleaning (Preventative) To help prevent odors or humidity accumulation leave the door open with the door stand ventilation feature (on select models) for a few hours after use or whenever the washer is not in use. CAUTION WARNING HARMFUL VAPOR HAZARD DO NOT use or mix liquid chlorine bleach with other household chemicals such as toilet cleaners, rust removers, acid or products containing ammonia.
Care & Cleaning 25 6. Replace the insert by pressing it in place until you hear a slight click. 7. Return the dispenser drawer to the unit. Cleaning the Adaptive Dispenser™ 1. Remove the drawer by pulling the dispenser out until it stops. 2. Reach back into the right rear corner of the dispenser cavity and press down firmly on the lock tab. Pull out the dispenser drawer. Rear 3. Remove the detergent cup and top cover from the dispenser drawer. 4. Remove the bottom cover from the dispenser drawer.
Care & Cleaning Inside Cleaning (Aggressive) In cases where clean washer cycle along with care and cleaning of rubber gasket folds isn’t done, and severe odor or residue buildup have developed, follow the below cleaning procedure to help alleviate the problem. IMPORTANT See Inside Routine Cleaning (Preventative) for future cleaning maintenance which is necessary to avoid repeating issues. Three Compartment Preventative Cleaning Cleaning Procedure-Washer Drum Ensure the wash tub is empty.
Care & Cleaning 27 Outside Routine Cleaning • When washing is completed, wipe top and sides of washer with a damp cloth. • Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers • If the cabinet becomes stained, clean with diluted chlorine bleach (1 part bleach to 8 parts water). Rinse several times with clear water. • Remove glue residue from tape or labels with a mixture of warm water and mild detergent. Or, touch residue with the sticky side of tape.
Care & Cleaning Water Inlet Hose Inspection Periodically inspect all water inlet hoses for water leaks, wear, cuts, corrosion and bulges. Replace all hoses, if any sign of the above is visible. All hoses should be replaced every 5 years to reduce the risk of hose failures. When replacing hoses, refer to the Installation Instructions for proper installation. DO NOT overtighten or cross thread the fittings. DO NOT allow the hose to rub against sharp objects.
Solutions to Common Inquiries 29 Normal Operating Sounds You may or may not hear the following sounds from your new washer: A. DRAIN HOSE The washer has a flexible drain hose to carry water from the washer to the stand pipe of your home. You will hear water flowing into your stand pipe. This is a normal part of the operation of the washer. B. WATER VALVES/DISPENSER As water enters the dispenser system, it is common to hear a water flowing sound.
Solutions to Common Inquiries Common Washing Inquiries Many washing problems involve poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory washing results, follow these suggestions provided by The Soap and Detergent Association.
Solutions to Common Inquiries 31 PROBLEM POSSIBLE CAUSES Pilling (Fibers ball up and cling to fabric.) • Pilling is normal with synthetic and permanent press fabrics. This is due to abrasion from normal wear. Residue • Undissolved detergent. or powder • Some granular deteron dark gents can combine with items; hard water minerals to Stiff, harsh form a residue. fabrics. • Overloading washer. Wrinkling • Overloading washer. • Incorrect wash cycle for wash load.
Solutions to Common Inquiries PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Residue • Moisture in washer. • Perform clean • Run dehumidifier in stain washer cycle laundry room. • Use of non-HE deterbuildup in gent. • Scrub gasket with • Avoid overfilling gasket Comet™ Spray Gel detergent and fabric • Overdosing detergent. • Overloading wash drum. Mildew Stain Remover softener compart- use brush to remove ments of dispenser. • Leaving a wet load set stains. • Dry the inside of in washer.
Before Calling 33 Before Calling Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this washer. OCCURRENCE POSSIBLE CAUSE SOLUTION NOISE Please refer to “Normal Operating Sounds” at the beginning of this section High pitch “jet engine” noise Rattling and clanking noise • A certain amount of motor whine is normal during the spin cycle.
Before Calling OCCURRENCE POSSIBLE CAUSE SOLUTION Washer does not • Electrical power cord may start not be plugged in or connection may be loose. • House fuse blown, circuit breaker tripped, or a power outage has occurred. • Make sure plug fits tightly in wall outlet. • Reset circuit breaker or replace fuse. DO NOT increase fuse capacity. If problem is a circuit overload, have it corrected by a qualified electrician. If problem is a power outage, call local electric company.
Before Calling 35 OCCURRENCE POSSIBLE CAUSE Warm or hot wa- • Hot water heater is set too ter is not hot low or is a distance from enough washer. SOLUTION • Measure hot water temperature at nearby faucet with candy or meat thermometer. Water temperature should be at least 120°F (49°C). Adjust water heater as necessary. • Hot water is being used • Avoid using hot water elsewhere elsewhere in the house. before or during washer use. There may not be enough hot water available for proper cleaning.
Warranty Information For the applicable warranty period as set forth below, as measured from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Warranty Periods: ●●All parts — One year including labor. In addition, your appliance is covered by a one year, parts only, limited warranty.
electrolux.
