Installation Guide

2
INSTALL THE RAILS
Disconnect the microwave oven from the receptacle.
Remove everything out of the microwave oven, including
packing, Owner’s Manuals, turntable and turntable support.
A protective film has been applied to some microwave
oven and trim kits. If applied, remove the film. Turn over the
microwave oven and secure the rails to oven Base Plate
by inserting 4 screw A-short screws.
the microwave oven.
1
LOCATE AND INSTALL THE EXHAUST DUCT
Set Exhaust Duct into the front cabinet microwave oven
cutout and center it right and left. Push back until the
front flange is against the cabinet front wall. Mount
the Exhaust Duct using 3 screw A - short screws.
Installation Instructions
Short
Screws
Exhaust Duct
Mounting Holes
3
INSTALL THE REAR DUCT
1. Gently return microwave oven to its upright position.
2. Remove screw A-short screw.
3. Align the rear duct with the back of microwave oven, as
shown.
4. Slide 2 tabs into the slots on the right side of the back of
microwave oven.
A. Rear duct tabs
B. Slots
A B
Screw A -short screw
Screw A-
EN-4
Microwave
Oven Bottom
Rail
Flanges
Door
Short
Screws
Screw A-
See Illustration 5.
Be careful not to scratch
Illustration 5
5. Use 2 screw A -short screws to secure top of rear duct to
of microwave oven, as shown.
A. Screw A -short screws (2)
B. Rear duct
C. Back of microwave oven
A
B
C
the back