User manual

Problem Possible cause Solution
The unit is defective. Refer to "Replacing the
control unit".
The compressor op-
erates continually.
The temperature is not set
correctly.
Set a higher temperature.
The door is not closed
correctly.
Refer to "Closing the door".
The door has been
opened too frequently.
Do not keep the door open
longer than necessary.
The food temperature is
too high.
Let the food temperature
decrease to room tempera-
ture before storage.
The room temperature is
too high.
Decrease the room temper-
ature.
Water flows on the
rear plate of the re-
frigerator.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
This is correct.
Water flows into the
refrigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector.
Make sure that products do
not touch the rear plate.
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre. You can find
the list at the end of this manual.
7.1 Replacing the control unit
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the con-
trol unit. Contact your Service Center.
7.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
ENGLISH 31