User manual

20 electrolux
GB
Use of the freezer compartment
The freezer is provided with the
symbol which means that it is
suitable for freezing fresh food and
for long term storage of frozen and
deep-frozen food.
Storage of frozen food
When first starting-up or after a period
out of use, before putting the products in
the compartment let the appliance run at
least 12 hours. To obtain the best
performance from this appliance, you
should:
if large quantities of food are to be stored,
remove all drawers and baskets from
appliance and place food on cooling
shelves.
Pay careful attention not to exceed load
limit stated on the side of the upper
section (where applicable).
Temperature regulation
The temperature may be regulated
between -15°C and -24°C.
We suggest setting the internal
temperature of approximately -18°C,
which guarantees proper freezing and
conservation of the frozen foods.
Attention!
During the stability period by the first
starting the temperature displayed can
not correspond to the setting
temperature. During this time it is
possible that the temperature displayed
is different than the setting temperature.
Attention!
Difference between the temperature
displayed and temperature setting is
normal. Especially when:
- a new setting has recently been
selected
- the door has been left open for a long
time
- warm food has been placed in the
compartment
Difference until 5°C inside the
compartment are quite normal.
During normal functioning the indicator
shows the warmest temperature inside
the compartment.
Important
In the event of accidental defrosting,
for example due to a power failure, if
the power has been off for longer that
the value shown in the technical
characteristics chart under "rising
time", the defrosted food must be
consumed quickly or cooked
immediately and then refrozen (after
cooling).
Excessive temperature alarm
An increase in the temperature in the
freezer compartment (for example due to
an power failure) is indicated by:
- flashing temperature;
- freezer compartment flashing ;
- flashing of the icon ;
- sounding of buzzer.
When normal conditions are restored:
- the acoustic signal shuts off;
- the temperature value continues to
flash;
When you press key "E" to de-activate the
alarm, the highest temperature reached
in the compartment appears on indicator
for some seconds. Then it returns on
the normal operation showing the
temperature of the selected
compartment.
During the alarm phase, the buzzer can
be switched off by pressing key E.