Owner's manual

Problem Possible cause Solution
Upper or lower
square is shown in
the temperature dis-
play.
An error has occurred in
measuring the temperature.
Call your service representa-
tive (the cooling system will
continue to keep food prod-
ucts cold, but temperature
adjustment will not be possi-
ble).
DEMO appears on
the Display.
The appliance is in demon-
stration mode (DEMO).
Keep pressed approximately
10 sec. the Mode button
since a long sound of buzzer
is heard and the Display
shut off for a short while: ap-
pliance start works regularly.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1
2
1.
Press on the rear hook of the lamp
cover by a screwdriver and at the
same time pull and rotate the cover in
the direction of the arrow.
2.
Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cov-
er).
3.
Fix the lamp cover into its original posi-
tion.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the
light comes on.
6.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
7. INSTALLATION
WARNING!
Read the "Safety Information" care-
fully for your safety and correct op-
eration of the appliance before in-
stalling the appliance.
7.1 Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate
of the appliance:
ENGLISH 33