User manual

10.3 Cleaning the door gasket
• Regularly do a check of the door
gasket. The door gasket is around the
frame of the oven cavity. Do not use
the appliance if the door gasket is
damaged. Contact an Authorised
Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.
10.4 Removing the shelf
supports and removing the
catalytic panels
To clean the oven, remove the shelf
supports and remove the catalytic panels.
CAUTION!
Be careful when you remove
the shelf supports. The
catalytic panels are not
attached to the oven walls
and can fall out when you
remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall. Hold the rear shelf
runners and catalytic panel in place
with the other hand.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point
to the front.
10.5 Catalysis
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Clean the oven door inner glass with warm
water and a soft cloth.
Remove all accessories.
The walls and the top of the cavity are
catalytic-coated. They absorb fat and dirt
at a big heat without smell.
To support this self-cleaning process heat
the appliance without any food regularly.
Spots or discolouration of the
catalytic surface have no
effect on catalytic properties.
1. Set the Catalysis function. Refer to
"Oven functions".
The display shows CATA and the duration
of the cleaning procedure (1 hour). You
cannot set the duration, but you can use
the End function to delay the start of the
cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2. Push a button or open the oven door
to stop the acoustic signal.
3. Clean the bottom of the appliance
with a soft and moist sponge.
To stop Catalysis before it finishes, turn
the knob for the oven functions to the off
position.
10.6 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
ENGLISH
23