User manual

The steam cleaning functions support the
steam cavity cleaning of the appliance.
For a better performance
you should start the cleaning
function when the appliance
is cool.
The specified time is related
to the duration of the
function and does not
include the time required for
cleaning of the cavity by the
user.
When the steam cleaning function is
active, the lamp is off.
1. Fill the water drawer to the maximum
level (around 950 ml of water) until
the acoustic signal sounds or the
display shows the message.
2. Activate Steam Cleaning function -
S2. Refer to "Activating a cleaning
function".
The duration of the function is around
30 minutes.
An acoustic signal sounds when the
programme is completed.
3. Touch a sensor field to deactivate the
signal.
4. Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water to clean the cavity.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. Let the appliance
dry fully with the door open. To speed up
the drying you can close the door and
heat up the appliance with True Fan
Cooking at temperature 150°C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.
Repeat the procedure a second time if
the level of dirt is high.
12.8 Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you
should perform the function: S2.
You can enable / disable this function in
the settings menu.
12.9 Steam generation system
- Descaling - S3
When the steam generator operates,
there is an accumulation and deposition
of limestone inside because of calcium
contents in the water. This can have a
negative effect on the steam quality, on
the performance of the steam generator
and on the food quality. To prevent this,
clean the steam generation circuit from
residual stone.
Select the function from the menu:
.
The duration of the complete procedure
is about 2 hours.
The light in this function is off.
1. Remove all accessories.
2. Make sure that the water drawer is
empty. Activate Tank Emptying - S1
function if needed.
3. Put the tray on the first shelf position.
4. Put 250 ml of the descaling agent in
the water drawer.
5. Fill the remaining part of the water
drawer with water to the maximum
level until the acoustic signal sounds
or the display shows the message.
The duration of the procedure is
about 1 hour 40 minutes.
6. Activate Descaling function - S3.
Refer to "Activating a cleaning
function".
7. After the end of the first part, empty
the tray and put it on the first shelf
position again.
8. Activate the Rinsing function. Refer
to "Steam generation system -
Rinsing - S4".
Remove the tray after the end of the
procedure.
If the function Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance dry
fully with the door open.
ENGLISH 43