User manual

Problem Possible cause Remedy
The lamp does not oper‐
ate.
The lamp is defective. Replace the lamp.
The display shows F111. The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
Put the plug of the core
temperature sensor as far
as possible into the socket.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. • Turn off the oven with
the house fuse or the
safety switch in the fuse
box and turn it on again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
Steam and condensation
settle on the food and in
the cavity of the oven.
You left the dish in the
oven for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activa‐
ted.
Refer to "Basic Settings" in
"Daily use" chapter.
The descaling procedure is
interrupted before it finish‐
es.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finish‐
es.
The function was stopped
by the user.
Repeat the procedure.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
You did not fill the water
drawer to the maximum
level.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is
on a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast‐
ing pan on the first shelf
position.
The cleaning function is in‐
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in‐
terrupted before it finishes.
The function was stopped
by the user.
Repeat the procedure.
www.electrolux.com50