User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. BEFORE FIRST USE
- 6. DAILY USE
- 7. CLOCK FUNCTIONS
- 8. AUTOMATIC PROGRAMMES
- 9. USING THE ACCESSORIES
- 10. ADDITIONAL FUNCTIONS
- 11. HINTS AND TIPS
- 11.1 Cooking recommendations
- 11.2 Advice for special heating functions of the oven
- 11.3 Full Steam
- 11.4 Turbo Grilling and Full Steam combined
- 11.5 Humidity High
- 11.6 Humidity Low
- 11.7 Steam Regenerating
- 11.8 Baking
- 11.9 Tips on baking
- 11.10 Baking on one level
- 11.11 Bakes and gratins
- 11.12 Moist Fan Baking
- 11.13 Multilevel Baking
- 11.14 Crispy baking with Pizza Setting
- 11.15 Roasting
- 11.16 Roasting
- 11.17 Grill
- 11.18 Frozen Foods
- 11.19 Slow Cooking
- 11.20 Preserving
- 11.21 Drying
- 11.22 Bread Baking
- 11.23 Food Sensor table
- 11.24 Information for test institutes
- 11.25 Information for test institutes
- 12. CARE AND CLEANING
- 12.1 Notes on cleaning
- 12.2 Recommended cleaning products
- 12.3 Removing the shelf supports
- 12.4 Steam Cleaning
- 12.5 Cleaning Reminder
- 12.6 Steam generation system - Descaling
- 12.7 Descaling reminder
- 12.8 Steam generation system - Rinsing
- 12.9 Tank Emptying
- 12.10 Removing and installing the door
- 12.11 Replacing the lamp
- 13. TROUBLESHOOTING
- 14. ENERGY EFFICIENCY
The duration of the function is around 6
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press .
Remove the baking tray after the end of
the procedure.
12.10 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
1
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
12.11 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
www.electrolux.com48