User manual

10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of any symbol.
1. Turn on the oven.
2. Set a heating function.
3. Press
again and again until the
display shows: Duration.
4. Set the time.
5. Press again and again until the
display shows: Set + Go.
6. Press
to confirm.
Press any symbol (except for ) to start
the function: Set + Go. The set heating
function starts.
When the heating function ends, a signal
sounds.
• Function Lock is on when
the heating function
works.
• The menu: Basic Settings
lets you turn the function:
Set + Go on and off.
10.5 Automatic Switch-off
For safety reasons the oven turns off
automatically after some time if a heating
function works and you do not change
any settings.
Temperature (°C) Switch-off time
(h)
30 - 115 12.5
120 - 195 8.5
200 - 230 5.5
The Automatic switch-off
does not work with the
functions: Light, Food
Sensor, Duration, End Time.
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the oven is
turned off, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the oven is turned on.
– if you touch a symbol during the
night brightness (apart from ON /
OFF), the display goes back to
the day brightness mode for the
next 10 seconds.
– if the oven is turned off and you
set the function: Minute Minder.
When the function ends, the
display goes back to the night
brightness.
10.7 Cooling fan
When the oven operates, the cooling fan
turns on automatically to keep the
surfaces of the oven cool. If you turn off
the oven, the cooling fan can continues
to operate until the oven cools down.
10.8 Mechanical door lock
The door lock is turned off when you buy
the oven.
CAUTION!
Only move the mechanical
door lock device horizontally.
Do not move it vertically.
www.electrolux.com28