User manual

7.2 Count Up Timer
The Count Up Timer is not
activated if Duration and End
are set.
The Count Up Timer starts to count when
the appliance starts to heat.
To reset the Count Up Timer, touch
and at the same time until the display
shows "00:00" and the Count Up Timer
starts to count up again.
7.3 Setting the DURATION
1. Activate the appliance and set an oven
function and temperature.
2. Touch again and again until the
display shows .
flashes in the display.
3. Use or to set the minutes for
DURATION.
4. Touch to confirm.
5. Use or to set the hours for
DURATION.
If you touch while you set the
DURATION, the appliance switches to
the setting of the END function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display.
The appliance deactivates.
7. Touch a sensor field to stop the
acoustic signal.
8. Deactivate the appliance.
7.4 Setting the END
1. Activate the appliance and set an oven
function and temperature.
2. Touch again and again until the
display shows .
flashes in the display.
3. Use or to set the END and
to confirm. First you set the minutes
and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes. symbol
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field to stop the
acoustic signal.
5. Deactivate the appliance.
7.5 Setting the MINUTE MINDER
Use the MINUTE MINDER to set a
countdown (maximum 2 h 30 min). This
function has no effect on the operation of
the oven. You can set the MINUTE
MINDER at any time and also when the
appliance is off.
1. Touch .
and "00" flash in the display.
2. Use or to set the MINUTE
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch and at the same time
to reset the set time.
4. Touch or the MINUTE MINDER
starts automatically after five seconds.
When the set time ends, an acoustic
signal sounds for two minutes and 00:00
and flash in the display.
5. Touch a sensor field to stop the
acoustic signal.
7.6 Setting the Time delay
function
The DURATION and END can be
used at the same time, if the appliance is
to be switched on and off automatically
later. In this case, first set the DURATION
and then the END function (refer
to "Setting the DURATION" and "Setting
the END" ).
When the Time delay function
is activated, the display
shows a static symbol of the
oven function, with a dot
and . The dot shows
which clock function is on in
the Clock / residual heat
display.
www.electrolux.com12