EQACF01SXWT EN USER MANUAL 1
Welcome Contents Thank you for choosing Frigidaire. Our water dispensers are developed with high technical and quality standards, with features to offer you even more comfort. Read all instructions before using this appliance. This book contains valuable information about operation, care and service. Keep it in a safe place. You expect all this from Frigidaire.…and we deliver. Safety ..................................................................................................................
Safety To reduce risk of injury and property damage, user must read this entire guide before assembling, installing and operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage. This product dispenses water at very high temperatures. Failure to use properly can cause personal injury.
Product description Installation Parts names Placement 1 9 10 2 3 4 11 5 The product must be installed in an easily accessible location in case of repairs. Put the appliance on a flat surface and keep a minimum distance of 25 cm from the wall. Make sure that the ventilation openings of the product are not being obstructed. 6 12 7 Use the appliance indoors, where is no likelihood of rain or bad weather, as there is damage risk to the product electrical system.
Installing the water bottle Before putting the water bottle: 1. Clean the inside of the water cooler, where the water bottle is placed, with warm water and mild detergent and sterilize as indicated in Care and cleaning section. 2. Clean and sterilize also the water bottle, especially the part that will be inside the water cooler. 3. Leave the protective plastic cap on the bottle, where The product has a hole punch. If the user prefers not to use the hole punch, you can pull it off.
How to use Activate heating and cooling This unit will not dispense hot or cold water until the switchers are activated. To activate, push top side of power switches in to start heating and cooling water: • If you do not want to heat water, push bottom side of red switch in. • If you do not want to cool water, push bottom side of green switch in. Dispensing water This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors can accumulate in the tank and lines.
Care and cleaning This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior to drinking any water. Wipe with a soft, clean piece of cloth in part outside of water dispenser regularly. The water inside the bottle must not contain chlorine additive. So it’s very important that the inside of the water dispenser is sterilized and clean.
Troubleshooting Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling the service technicians, before contacting the service center please carry out the check listed below. Problem Possible cause(s) Solution a) Electric plug out of the socket. b) Bonded in different voltage. c) Lack of electric power or fuse blown. d) Make sure cold water switch in the rear side of dispenser is ON. e) Voltage drop. a) Plug in. b) Connect in correct voltage.
Technical informations MODEL Volt-Freq. NOTES WITH CABINET EQACF01SXWT 220V - 50/60Hz Max. power 570 W Heating power 450 W Cooling power 120 W Cold water 2L/H Heat water 4L/H Environmental temp. Humidity Net weight Prod. dimens.