User manual

Preparing the unit for Natural Gas installation
This barbecue is supplied set up for Natural Gas and is
labelled accordingly. A Universal LPG conversion kit is
included if required. Conversion of this unit to Universal LPG
must be carried out by a qualified licensed person.
A Certificate of Compliance must be issued to the owner on
completion of the installation and conversion.
Fit Natural Gas installation pipe to the barbecue gas inlet to
enable access to the regulator in the installed position.
When tightening the regulator or any other connection do
not over-tighten.
1. Fitting the Natural Gas installation pipe
• Fitthepipeensuringthebluesealingwasherisin
place. Do not over-tighten.
2. Fitting the regulator
• Fittheregulatorensuringthebluesealingwasher
is in place and the arrow indicating gas flow is
correct. Do not over-tighten.
3. Fit the hose
• Applythreadtapeorsealanttothemalethread
on the hose and screw into the regulator. Do not
over-tighten.
4. Fit to mains
• Connectthebayonetendtomains
Preparing the unit for Natural Gas connection
to mains
For Natural Gas connection a bayonet connection point
should be installed by a licensed gas fitter prior to installing
the barbecue unit.
2 assembling electrolux integrated barbecue
gas type natural gas universal LPG
Maximum gas consumption 50 MJ/hr 50 MJ/hr
Injector orifice diameter 1.75mm 0.95mm
Number of injectors 4 4
Regulator pressure 1.00 kPa 2.75 kPa
Notes
This appliance MUST be installed and serviced only by
a qualied licensed person.
This product is intended for outdoor use only.
This product must be installed as per the instructions
which requires the installation of venting to enable
the barbecue to operate correctly. Failure to provide
adequate ventilation for supply of air to the appliance
may result in poor burner performance or excessive
heat build-up within the mounting enclosure.
Ventilation holes in the unit must not be obscured by
the installation.
Gas connection detail
electrolux integrated barbecue gas specifications/natural gas installation 3
Natural Gas installationGas specifications
408mm
137mm
regulator – ensure
arrow is pointing in
the right direction
hose with tapered
thread – thread tape
required
sealing washer
1. Remove all components from box.
2. Attach heat shield to rear of unit by inserting the three
top tabs into the rear holes and sliding the shield down.
3. Position flame tamers into desired locations (under
where grill sections will be fitted) and fix back edge of
the flame tamer into rear of barbecue body.
4. Fit left and right hand oil reservoirs at front of barbecue.
Assembling the barbecue
5. Place hotplate and grill sections into desired positions
ensuring that the flame tamers are under grill sections
NOTE ensure that grill assemblies are orientated
correctly so that the surface of the grill is sloping
forward to allow oil to drain into oil reservoirs.
6. After installation in bench, attach slimline lid or roasting
hood as described in “Fitting the slimline lid or roasting
hood” section of this manual.
46mm
Natural Gas
installation pipe
barbecue gas inlet
back
front
assembled grill
sealing washer