User manual

10 lid safety leg/cleaning and care electrolux integrated barbecue
The Electrolux Integrated barbecue has been constructed
from select grade stainless steel which, if not cared for, may
discolour over time. To keep your barbecue looking its best
we recommend that the cooking surfaces are cleaned after
every use.
warning
Please ensure that your barbecue is switched
off and has cooled down before following the
instructions below.
Cleaning of Stainless Steel components
Hot Plate and Grill
• Removeallsolidmaterialsandexcessgreasefromgrill
and hotplate using scraper or wire brush
• Tomakecleaningeasy,thetwogrillhalvescanbe
removed with the hotplate. For stubborn stains, simply
soak the grill and plate components in hot soapy water
before rinsing thoroughly
• Ensurethatallsurfacesaredriedwithacleandrycloth
Other stainless steel surfaces
caution
Do not use abrasive or caustic cleaners, scourers or
metal scrapers on these stainless steel surfaces as they
may permanently scratch and damage your barbecue.
• Washallstainlesssteelcomponents,includingthe
slimline lid, the roasting hood and control knobs with
a soft dishcloth using hot soapy water
• Thebarbecueinteriorcanbewipeddownwithasoft
cloth in hot soapy water. The rear panel of the interior
is removable for easy cleaning
• Ensurethatallsurfacesaredriedwithacleandrycloth
caution
Take extra care (particularly when cleaning on and
around the control knobs) to ensure that water and
soapy residue do not enter the control panel, where
the valves are or into the burners. Care should also be
taken not to disturb the spark electrode. A distance
of 5mm should be maintained between it and the
burners (see diagram below).
To ensure that the user remembers to turn off the gas
before closing the lid, a pivoting safety leg has been fitted.
When closing the lid the safety leg will pivot forward and
rest against the trim surface to prevent the lid closing.
After ensuring the gas has been turned off, to fully close
the lid, the leg needs to be rotated backwards.
warning
THE SLIMLINE LID MUST NOT BE CLOSED WHEN
THE BURNERS ARE OPERATING.
Closing the lid during burner operation can cause
discolouration and damage to the lid and barbecue unit.
Cleaning and careLid safety leg – slimline lid only
electrolux integrated barbecue cleaning and care/maintenance/troubleshooting 11
Maintenance
Troubleshooting
problem possible cause remedy
Barbecuewon’t
light
No gas Check isolation valve
is ON
Gas bottle empty – refill
or change gas bottle
Ignition system
not working
Check battery – should
hear a clicking noise
when the knob is
depressed
Replace battery
Manually light the
barbecue
Ignition electrode
wet or dirty
Gently clean and dry
electrode ensuring
position is correct
Excess smoke
being emitted
from the cooking
area
Gas valve set too
high
Turn gas valves down or
turn off selected burners
Smell of gas
DO NOT
ATTEMPT TO
LIGHT THE
APPLIANCE
Gas leak Turn off gas at the
isolation valves
Check for leaks, tighten
joints
If problem persists call
Electrolux Service
The ignition system
To change the battery rotate the cover anti-clockwise
to release. Lift off the cover to access spring and battery.
Lift out the spring and battery. Replace with a new AA
battery and replace the cover. Test by depressing the
knob and an audible ‘clicking’ sound should be heard.
Note
Ensure that the battery has been placed in the
correct orientation.
Air vents
The mounting enclosure air vents should be checked prior
to each use, to ensure they are clear of any obstructions
that may affect the free flow of air.
Stainless steel burners
Burnersshouldbecheckedatleastonceperyearand
cleaned as necessary. Inspect burners to ensure no
residues have been deposited and gas ports are clear.
Cleaning the Oil Reservoirs
The Integrated barbecue has a unique oil management
system which uses overlapping channels to drain all oil
to the front into easily removed reservoirs and should be
cleaned after each use.
• Toremovereservoirs,pullupwardsfromthefrontofthe
barbecue and dispose of the contents of the catchment
responsibly. Rinse oil reservoirs in warm soapy water.
The reservoirs can be placed in the dishwasher
if desired.
tips and information
Special note on “tea staining”
Sometimes stainless steel surfaces are affected by a brown
discolouration called tea staining. This usually occurs in
areas which use high heat and can be easily removed using
specialised stainless steel cleaners. For best results, we
recommend that specialised cleaners be used regularly on
all stainless steel components. You will find these cleaners
at most hardware stores.
tips and information
Special note on stainless steel
The stainless steel panels may distort while in use but will
return to normal when cold.
5mm
pivoting safety leg
pivoting safety leg