User Guide

8 www.electrolux.com
Locating the refrigerator
CAUTION
Automatic aerosol systems (such as
insect control) should not be located
adjacent to the product as the spray
may cause long term damage to the
external plastics of he appliance.
Do not put the refrigerator in a location that
is too cold or is unprotected, for example in a
garage or on a veranda. The
ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding
areas of high moisture or humidity.
Ensure the refrigerator is located on an even
surface.
4. INSTALLING YOUR NEW APPLIANCE
Unpacking
ENVIRONMENT
Most of the packing materials are
recyclable. Please dispose of those
materials through your local
recycling depot or by placing them
in appropriate collection containers.
Important – check for any damages or
marks. If you find the refrigerator is damaged or
marked, you must report it within 7 days should
you wish to claim for damage/ marks under the
manufacturers warranty. This does not affect
your statutory rights.
Clean your refrigerator thoroughly following
the instructions in the “Cleaning” section and
wipe off any dust that has accumulated during
shipping.
Error Code What It Means What to do
Communication Error
If you see this icon displayed
(Ice & Water model) or the top
temperature icon is flashing it
means that the control has lost
contact with the main control
board.
The appliance will operate
at its last known setting, all
auxiliary functions will not work.
Turn the unit off at the power point
for 5 minutes and then turn it back
on.
Under most circumstances this will
reset the display enabling normal
function to continue.
If the error re-occurs then call for
service.
Sensor – Open
Circuit / Short Circuit
If you see this icon displayed
(Ice & Water model) or any
combination of the second and
fourth temperature icons are
flashing it means that an error
has been detected on a sensor.
The refrigerator will run in a
default cycle to prevent food
spoilage.
Call for service.
Ice cube tray water
fill not detected
This error indicates that when
an ice harvest occurred and a
tray water fill was attempted,
that the tray sensor did not get
above 0°C.
Check the following:
Water turned on at tap, water filter
not blocked, no kinks in water tube.
If after checking these items and
they do not appear to be the cause
of the error, call for service.
Non I&W
Non I&W
Non I&W
Non I&W
Non I&W
Non I&W
Error codes