I N F O I N S T R U C C I O N E S PA R A L A I N S TA L A C I O N Y E L U S O INSTALLATION AND INSTRUCTION MANUAL FRIGORIFICO-CONGELADOR FRIDGE-FREEZER ER 3136 I ER 3136 I 2222 240-24 This document was created with FrameMaker 4.0.
CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 12 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Power connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Cleaning the appliance’s interior . . .
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
INSTALLATION Attention Door reversibility (Fig. 1) If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to break the spring lock before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Before fitting the appliance in the kitchen furniture and connecting it to the power supply, if necessary, change the door opening side (from right to left).
Installation of the appliance in a fitted kitchen unit (Fig. 3) Fig. 3 18mm ª Drill the unit using a Ø 2.5 mm drill (10 mm max. penetration); 4 3 2 ª Fix the square fitting (1) to the appliance and apply the rubber seal; 13mm ª If the door is not already assembled fix the square fitting (2) to the refrigerator and fitting (3) to the unit column. ª Fit the refrigerator into the space recessing it by 48 mm in relation to the unit base (Fig.
Instructions to assemble the refrigerator door to the kitchen unit door Position the runners (C) at the top and bottom of the inside of the kitchen unit as shown in Fig. 5 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. Remove the little plates and make the holes with a diam. of 3,2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm).
USE Operation - Temperature regulation Rotate the thermostat knob clockwise until reaching the desired position (beyond the «O» = stop position); the best position is between 3 and 4. 1. Cold cuts, cheese, butter, milk 2. Meat and fish 3. Fruit and vegetables. Fig. 9 The temperature is automatically regulated and can be increased to achieve a higher temperature (less cold) by rotating the thermostat toward lower settings or diminished (more cold) rotating the knob towards higher settings.
Storage door accessories The shelves can be easily removed if they are to be cleaned or positioned at different heights. To do that, push them upwards (see Fig. 11). Fig. 11 Never put fizzy drinks in the freezer as they might well burst. A word of warning about ice lollies: they should not be eaten straight out of the freezer as this might cause cold burns. The maximum amount of food which is freezable in 24 hours is indicated on the rating plate.
Freezer compartment defrosting Refrigerator defrosting The air humidity that penetrates inside the appliance when opening its door, accumulates on the evaporator and particularly on its upper part, thus creating a layer of frost. To avoid excessive formation of frost do not leave the door open more than necessary. The formation of a thin layer of frost (as for example on the front edge of the freezer) does not require complete defrosting.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior cleaning Wash the interior of the appliance and its accessories with lukewarm water and sodium bicarbonate (one spoon in 4 litres of water). Rinse and dry carefully. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly.
