User manual

4
INSTALLATION
Caution
If this appliance featuring magnetic door seals is to re-
place an older appliance having a spring lock (latch)
on the door or lid, be sure to make that spring lock un-
usable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Location
Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc. Best
results are obtained with a room temperature ranging
between +18 ° C and +43 ° C.
Make sure that there is nothing at the back, at the top
and at the bottom of the appliance to obstruct air cir-
culation.
For a more efficient operation of the appliance, the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any, should
be at least 100 mm (see Fig. 1/A).
However, the best solution would be that shown in
Fig. 1/B with no overhanging furniture.
Two adjustable feet make it possible to accurately lev-
el the appliance.
Fig. 1
Rear spacers
In the plastic envelope containing the Operating In-
structions are also included two wall spacers to be fit-
ted into the special openings provided on the back of
the appliance.
Push-fit the spacers into the openings, making sure
that arrow («A») is positioned as per Fig. 2 and then
turn the spacers through 45 ° until they lock in (arrow
in a vertical position).
Fig. 2
100 mm min.
A
B
D042
D039
A
45°
Electrical connection
Before you plug the appliance into an A.C. mains sup-
ply, make sure that the voltage and frequency shown
on the rating plate correspond to your home supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use an au-
totransformer having a minimum output of 500 VA.
Important
It is essential that the appliance be connected to an
efficient earth tap.
For this purpose the supply cable plug incorporates a
special earth contact.
If the sockets of your domestic wiring system are not
grounded, have the appliance connected to a sepa-
rate ground wire by a qualified electrician in accord-
ance with the existing safety regulations.
The manufacturer declines to accept any liability
should this safety rule not be observed.
This appliance complies with E.E.C directive No. 87/308
of 2.6.87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly. Do
not use detergents which will leave an odour or abra-
sive powders on the interior, as these will damage the
finish.