User manual

CAUTION!
Never install the water filter in an area of direct
sunlight.
Check for water leaks at all water connection points in
the first 2 to 3 hours after installation, and correct it in
case of any water leak. Recheck after 24 hours; if leak
still occurs, it is recommended to turn off water supply
and contact a licensed plumber for advice.
Water is to be connected as per diagram below.
sink
brackets
mains
water inlet
kitchen
cupboard
½" tap
fitting
filter
Step 1.
Ensure that the Ice Maker is switched OFF.
Step 2.
Disconnect refrigerator from power supply.
Step 3.
Connect tap fitting to water supply tap. Tap must be close
to the refrigerator.
Step 4.
Install brackets for filter close to tap. Plan to leave as much
tubing as possible behind the refrigerator to enable it to
be moved easily for cleaning or service.
CAUTION!
Do not screw the brackets into the refrigerator as this
may void your warranty and permanently damage the
refrigerator.
Step 5.
Write date on filter. The filter will need to be replaced
every 12 months.
date tted 1
Step 6.
Extend the red collar and clip a circlip around the collar at
both ends of the filter.
Step 7.
Fit filter to brackets with water flow arrow pointing up.
water
flow
direction
ICE & WATER INSTALL ATION
12