User manual

Movable shelves

The walls of the refrigerator have runners so that

shelves can be positioned as desired.

For better use of space, the front half-shelves can lie

over the rear ones.

D338

PR189

Positioning the door shelves

To permit storage of food packages of various sizes,

the door shelves can be adjusted in height.

To do this proceed as shown in the diagram.

PR190

Door reversal directions

1. Disconnect from the electricity supply.

2. Gently lay the fridge/freezer on its back with the

top held away from the floor by 5-8 cm (2-3

inches) of packing;

3. Remove the ventilation grill (D).

4. Unscrew the bottom hinge (E).

5. Slide out the fridge door from pin (G), unscrew

the latter and then refit it on the opposite side;

6. Remove the two screws which mask the holes for

fixing the hinge from the left hand side;

7. Replace the door and bottom hinge (E) on the

opposite side.

8. Remove the plug (F) from the ventilation grill (D)

and replace it on the opposite side. Re-assemble

the ventilation grill (D).

9. Unscrew the handle. Refit it on the opposite side

after having pierced the plugs with a punch.

Cover the holes left open with the plugs contained

in the documentation pack.

Attention

After completion of the door reversing operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that

case, wait for the natural fitting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdryer on a low setting.

PR228

Printed on recycled paper