User manual

27
Ouvrir la porte de lÕappareil et celle du meuble ˆ 90¡
environ. Introduire lÕŽquerre (B) dans la glissi•re (A).
Tenir ensemble la porte de lÕappareil et celle du
meuble et marquer la position des trous comme
lÕindique la figure. Enlever les Žquerres et pratiquer
des trous de 2 mm de Æ ˆ 8 mm du bord externe de
la porte. Remettre lÕŽquerre en place sur la glissi•re
et fixer avec les vis fournies.
8mm
PR167
A
B
En cas de fixation latŽrale de lÕappareil au meuble
colonne, desserrez les vis des Žquerres (D) et
dŽplacez celles-ci dÕapr•s la Fig.
Fixez ˆ nouveau. Appliquez le couvercle(E).
D
E
D734
PR168
PR167/1
D
B
Pour effectuer lÕŽventuel alignement de la porte du
meuble, utiliser le jeu des trous ovales.
A la fin des opŽrations, il est nŽcessaire de contr™ler
que la porte de lÕappareil se ferme parfaitement.
Fixer par encliquetage le couvercle (D) sur la
glissi•re (B).
30
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage the finish.
Operation
Insert the plug into the wall socket.
Open the refrigerator door and turn the thermostat
knob, clockwise, beyond the ÇOÈ (STOP) position.
The appliance will start to operate.
Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
¥ room temperature;
¥ how often the door is opened;
¥ the quantity of food stored;
¥ location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
USE