User manual

31
Installation
Positioning
 Place the refrigerator away from direct sunlight
and heat sources.
 Maintain recommended ventilation - see Fig. 1.
 Make sure the refrigerator is accurately levelled
turning the adjustable feet in order to avoid vibra-
tions and noises.
 This is a built in design to be aligned with other
furniture
Cleaning the interior
 Do not use alcohol or any cleanig product contai-
ning alcohol because it can damage the cabinet.
 Before using the appliance for the first time wash
the interior whith luke warm water and some neu-
tral soap so as to remove the typical smell of a
brand-new product arid then dry thoroughly.
 Do not use detergents or abrasive powders as
these will damage the finish.
 Remove security used for transportation.
Electrical connection
Before plugging the appliance make sure that the
voltage and frequency shown on the «Technical
Features» correspond to your home supply.
It is essential that the appliance be efficiently
earthed.
For this purpose the supply cable plug incorpora-
tes a special earth contact. If the sockets of your
domestic wiring system are not grounded, have
the appliance connected to a separate ground
wire in accordance with existing safety regula-
tions.
«THE MANUFACTURER DECLINES TO
ACCEPT ANY LIABILITY IF THIS SAFETY RULE
IS NOT OBSERVED».
Should a change of the supply cord be necessary,
remove the lid of the terminal board acting on «E»
and «F» as shown figure 3 in order to gain access
to the terminals. Fig. 3.
Starting  up
 Plug the appliance into the mains.
 Make sure the inner light «H» turns on when ope-
ning the door.
 Turn to intermediate position the knobs of the
«temperature regulators» «h» for refrigerating
compartment and «f» for freezing compartment.
Fig. 3
Fig. 2
Fig. 1