User manual

32
Changing the opening direction
of doors and Panelling
Fig. 6
Fig. 7
If you wish to change the opening side of the doors
proceed as follows:
1... Remove the handles of the doors.
2... Take off the plinth pressed onto cabinet.
3... Remove the lower hinge taking care for the lower
door not to fall off.
4... Lift the lower door off the central hinge.
5... Remove the central hinge taking care for the
upper door not to fall off and not to lose the plas-
tic washer.
6... Take the upper door off the upper hinge. Be
carefull not to lose the plastic washer.
7... Unscrew the plastic plugs located on the opposi-
te side of the central hinge and introduce them in
the holes occupied before by the hinge.
8... Unscrew the axle of the upper hing and screw it
into the hinge on the opposite side. Make sure to
fit in the metal washer for blocking.
9... Place upper door.
For the remaining parts proceed the other way
round.
Once finished make sure that all joints close
perfectly well all around the door and chek that
the internal light turns of when the fridge door
closes.
How to panel the doors
If your appliance is provided with metal strips for
panelling and you wish to do so proceed as follows:
1... Remove one of the side strips.
2... Loosen the screws of the remaining strips.
3... Start putting on the panel where you took off the
strip pushing it right up to the end.
4... Replace the strip on this side.
5... Tighten all screws
NOTE:
The panel dimensions must be 2 mm. shorter
than the doors. Maximun thickness of the panel is 4
mm.