User manual

3
Installation
Positioning
 Place the refrigerator away from direct sunlight
and heat sources.
 Maintain recommended ventilation - see Fig. 1.
 Make sure the refrigerator is accurately levelled
turning the adjustable feet in order to avoid vibra-
tions and noises, Fig. 2.
 This is a built in design to be aligned with other
furniture
 The appliance must be located in places of maxi-
mum temperature as follows:
If the temperature are higher than these both
above mentioned, the functions of appliance coudl
result reduced.
 Remove the shelves transport fastening red pie-
ces by sliding them (see fig. 3).
Cleaning the interior
 Do not use alcohol or any cleanig product contai-
ning alcohol because it can damage the cabinet.
 Before using the appliance for the first time wash
the interior whith luke warm water and some neu-
tral soap so as to remove the typical smell of a
brand-new product arid then dry thoroughly.
 Do not use detergents or abrasive powders as
these will damage the finish.
 Remove security used for transportation.
Electrical connection
m Before plugging the appliance make sure that the
voltage and frequency shown on the «Technical
Features» correspond to your home supply.
It is essential that the appliance be efficiently
earthed.
m For this purpose the supply cable plug incorpora-
tes a special earth contact. If the sockets of your
domestic wiring system are not grounded, have
the appliance connected to a separate ground wire
in accordance with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
Starting  up
 Plug the appliance into the mains.
 Make sure the inner light turns on when opening
the door.
 Turn to intermediate position the knob of the «tem-
perature regulator» (See knob in the Control and
Use paragraph).
Fig. 1
Fig. 2
SN +10 to +32ºC
N +16 to +32ºC
ST +18 to +38ºC
T +18 to +43ºC
Fig. 3