Operation Manual

Problem Possible cause Solution
The appliance has no power.
There is no voltage in the mains
socket.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
The lamp does not work.
The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.
1
2
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
TECHNICAL DATA
ERB29233X
ERB29233W
ERB34233X
ERB34233W
ERB36233X
ERB36233W
ERB40233X
ERB40233W
Dimension
Height 1540 mm 1750 mm 1850 mm 2010 mm
Width 595 mm 595 mm 595 mm 595 mm
Depth 658 mm 658 mm 658 mm 658 mm
Rising Time 20 h 20 h 20 h 20 h
Voltage 230 V 230 V 230 V 230 V
Frequency 50 Hz 50 Hz 50 Hz 50 Hz
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
electrolux 25