Refrigerator / Frigorifico INSTRUCTION BOOK INSTRUCCIONES DE USO GB ERC3712S GB DK 818 38 31--00/0 ES DK
Safety instructions GB Your new fridge may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance.
Description of the Appliance Model ERC3712S 7 1 2 1. 2. 3. 4. 5. 6. 7. 8. 8 1 8 1 4 1 5 5 GB 8 glass shelf bottle shelf bottle shelf egg holder vegetable drawer ventilation grille butter compartment door shelf 1 3 1 5 6 Control Panel 5 A B ACTION COOL C DE F G A. Refrigerator power switch Switches the refrigerator on and off. E. Yellow indicator lamp Lights when Action Cool is operating. B. Temperature display Shows the average temperature inside the refrigerator. F.
Using the fridge GB To start the fridge and set the correct temperature Switching on: Switch on the fridge by pressing the power switch. Setting the temperature Press the buttons until the desired temperature flashes in the temperature display (The temperature can be set between +1°C and +9°C.) "+" raises the temperature. "-" lowers the temperature. Once set, the temperature display shows "-" until the temperature inside the fridge reaches +9°C or below.
Switching off Switch off the cabinet by pressing the power switch. Keep the button pressed for approx. 1 second. Power to the cabinet is completely interrupted only when the power plug is disconnected. 5 ACTION COOL Alarms and other features Door open alarm If the fridge door remains open for more than 5 minutes, the red warning lamp starts flashing and an audible alarm sounds. To switch off the alarm: Press the "alarm shut-off button". The red warning lamp goes out when the door is closed.
Hints and Tips GB Saving energy · · Pay careful attention to where the cabinet is · · · · · · placed. See the section "Installation". When installed correctly, the cabinet will consume less energy. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. Thaw frozen food in the fridge.
Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor.
There is water on the cooling plate inside This is normal. During automatic defrosting, frost thaws on the the refrigerator. cooling plate. Water is running inside the refrigerator. Clean the water drain and drain hole inside the refrigerator using e.g. cotton swabs or a bottle cleaner brush. Some food products could have been placed near the rear of the appliance prevetung the water from running into the drain. Water comes out on the floor.
Technical specification Model ERC3712S Volume Refrigerator 361 l Width 595 mm Height 1800 mm Depth 600 mm Energy consumption 179 kWh/y Energy class A Rated power 110 W Installation GB GB Mains Cable Do not remove the power cord by pulling on its lead, particulary when the product is being pulled out of its niche. · Damage to the cord may cause a short-circuit, fire and/or electric shock.
Installing the cabinet When two appliances are placed beside each other, the distances enclosed in the plastic wrapping should be glued between the appliances. As shown in the illustration. Make sure that the power plug is not squashed or damaged by back of the product. · A damaged power plug may overheat and cause a fire. Do not place heavy articles or the product itself on the power cord. · there is a risk of a short circuit and fire. If the power plug socket is loose, do not insert the power plug.
Door Reversal 1 1. Close the cabinet and remove the plug from the electrical socket. 2 2. Remove the ventilation grille. There is a part on the grille that can be removed. Remove and reposition it on the other side. 3 3. Put the cabinet on a wooden board when it is laid down. Later, when raising the cabinet, it will be easier to grip under the cabinet thanks to the board. 4. On the upper part of the cabinet. Put the hinge pin on the other side. 4 5. On the lower part of the cabinet. a.
qÜÉ=bäÉÅíêçäìñ=dêçìé=áë=íÜÉ=ïçêäÇDë=ä~êÖÉëí=éêçÇìÅÉê=çÑ=éçïÉêÉÇ=~ééäá~åÅÉë=Ñçê=âáíÅÜÉåI=ÅäÉ~åáåÖ=~åÇ=çìíÇççê=ìëÉK jçêÉ=íÜ~å=RR=ãáääáçå=bäÉÅíêçäìñ=dêçìé=éêçÇìÅíë=EëìÅÜ=~ë=êÉÑêáÖÉê~íçêëI=ÅççâÉêëI=ï~ëÜáåÖ=ã~ÅÜáåÉëI=î~Åììã=ÅäÉ~åÉêëI ÅÜ~áå=ë~ïë=~åÇ=ä~ïå=ãçïÉêëF=~êÉ=ëçäÇ=É~ÅÜ=óÉ~ê=íç=~=î~äìÉ=çÑ=~ééêçñK=rpa=NQ=Äáääáçå=áå=ãçêÉ=íÜ~å=NRM=ÅçìåíêáÉë ~êçìåÇ=íÜÉ=ïçêäÇK bä=dêìéç=bäÉÅíêçäìñ=Éë=Éä=ã~óçê=Ñ~ÄêáÅ~åíÉ=ÇÉä=ãìåÇç=ÇÉ=~é~ê~íçë=é~ê~=ä~=ÅçÅáå~I=äáãéáÉò~=ó=ìëç=ÉñíÉêáçêK=j•ë=ÇÉ=RR ãáääçåÉë=ÇÉ=éêçÇìÅíçë=ÇÉä=dêìéç=bäÉÅí
