User manual

Problem Possible cause Solution
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Attach the melting water outlet to
the evaporative tray.
There is too much frost
and ice.
Food are not wrapped properly. Wrap the food better.
The door is not closed correctly. Refer to "Closing the door".
The Temperature regulator may
be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too low.
The Temperature regulator may
be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too high.
The Temperature regulator may
be set incorrectly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too high. Let the food temperature de-
crease to room temperature be-
fore storage.
The temperature in the re-
frigeration is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air cir-
culation in the appliance.
Large quantities of food to be
cooled were put in at the same
time.
Insert smaller quantities of food to
be cooled at the same time.
The appliance does not
operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
Connect a another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
The lamp does not work.
The lamp is in stand-by. Close and open the door.
The door has been open to long. Close the door.
The lamp is defective. Refer to "Replacing the lamp".
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.
electrolux 11