refrigerator INSTRUCTION BOOKLET GB ERES3500, ERES3500X 818 38 23--00/7 GB
Important Safety Instructions Your new fridge may have other functions compared to your previous one. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. Keep the instruction booklet. It will come in handy if you later sell the appliance or give it to somebody else.
Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . 17 Installing the appliance . . . . . . . . . . . . . . . . . . . . . . 15 When the water system is started for the first time . 16 Guide to use the instruction book The following Symbols will be found in the text to guide you through the instructions Safety instructions 1, 2, 3 ...
Control Panel (water dispenser) H I M L N H. Yellow indicator lamp Lights up when the locking function has been activated. I. Button for carbonated water. - Used for the choice of carbonated water. - For the engagement and disengagement of the locking function. J. Button for ordinary water. - Used for the choice of ordinary water. - Switches the background lighting on and off. K J - Switches off the indicator lamp for water filter replacement. K.
It is not necessary to reset the temperature when the cabinet is switched on after it has been out of use. The thermostat recalls the previously set temperature. Temperature inside the fridge Suitable storage temperature in the fridge is roughly +5°C. Storage temperature in the cabinet is even on all of the shelf levels. The vegetable box which is placed in the bottom has a temperature of 3-4°C warmer than the intended temperature setting.
Carbon filter's function: The built-in carbon filter means that strong smelling groceries can be placed near other groceries without affecting their taste or aroma. The functions of the water dispenser The locking function: The locking function is activated by the production plant. For temporary unlocking: Keep the button (I) or (J) pressed in for about three seconds until the yellow indicator lamp (H) goes out. The locking function is re-activated automatically after about three seconds.
Indicator lamp for the water filter: The water dispenser is fitted with an indicator lamp (K) which shows when it is time to change the water filter. When the indicator lamp stays on, then the water filter has been utilised to about 80 % of its expected lifetime. In this situation, it is recommended that you buy a replacement filter. When the indicator lamp starts flashing, the water filter has been utilised to 100% of its lifetime. Replace the filter without delay.
Bottle- and can holder The side of the bottle and can holder is moveable to enable a more flexible placement of cans and bottles in front of the grid. To allow the holder to be moved easier, when moving sideways, press the shelf backwards. During chilling of cans or bottles the article should be centrally placed in front of the grid to obtain the best chilling effect. The bottle support can be pulled out when chilling larger bottles.
Maintenance and Cleaning Removing the ventilation grille The ventilation grille can be removed, e.g. to wash the grille. Make sure the door is open when removing the ventilation grille. Unsnap the upper edge of the grille by pulling outward/downward. Then pull the grille straight out to completely remove it. Internal Cleaning Clean the cabinet at regular intervals.
Service during operation The water filter is replaced as follows: Place a piece of kitchen tissue or a dishcloth in the space under the filter. Remove the filter by turning it clockwise. A small amount of water will run out. Dry off and fit the new filter. See the section "When starting the water system for the first time". The water connection does not need to be switched off when changing the filter. Replacement filters can be ordered from Electrolux Service Force Centre.
Something Not Working Before contacting your local Service Force Centre check the following points: Symptom Solution " " is displayed in the temperature display. An error has occurred in measuring the temperature. Call your service representative. (The cooling system will continue to keep food products cold, but temperature adjustment will not be possible.) The temperature is too high inside the refrigerator. Set a lower temperature. Put food products in the right place inside the refrigerator.
Water flow very low Remove and clean the strainer in the connecting valve. Sediment in the water. Replace the filter or install a pre-filter. Only gas comes out when opening Incoming water pressure too high. Install a pressure-limiting device. Capacity temporarily exceeded. Wait for ten minutes. The water dispenser lamp flashes Leakage at the water connection. Remedy the leakage and empty the box by pulling out the red plug. See the illustration in "Connecting the water hose".
Technical Specification Model ERES3500/ERES3500X Volume Refrigerator 311 l Width 595 mm Height 1800 mm Depth 650 mm Energy consumption 175 kWh/år Energy class A Rated power 70 W Permissible water pressure (to ensure reliable function). The total flow in the system can vary, depending on local water conditions and/or water pressure. Lowest permissible water pressure. 2,5 bar (250kPa) Highest permissible water pressure.
Cleaning Wash the inside of the appliance using lukewarm water and bicarbonate of soda (5 ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Connecting the water hose. Remove the transport protector from the valve connector, see the illustration. Connect the water hose supplied with the hose fitting to the refrigerator water valve, which is located in a box behind the refrigerator.
Electrical cord Do not remove the power cord by pulling on its lead, particulary when the product is being pulled out of its niche. · Damage to the cord may cause a short-circuit, fire and/or electric shock. · In the event of damage to the appliance's main cable, only an authorised service company recommended by the manufacturer or a similarly qualified person may adjust it in order to avoid shock hazard for the user.
When the water system is started for the first time. The following should be carried out when the refrigerator is correctly connected to the water supply in the building: Open the tap on the water connection and start up the refrigerator. The water system main valve opens and the system starts to fill up. Wait for five minutes.
Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The appliance is supplied with a 13amp plug fitted.
Electrolux 8183823-00/7 18
Electrolux 8183823-00/7 19
www.electrolux.
