Owners Manual

15
DOOR HANDLE INSTALLATION
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

NOTE
Tighten all set screws so the screws are below the surface of the handle. Draw the handles
tight to the freezer and refrigerator doors with no gaps. Opening the opposite door while
tightening the Allen screw makes installation easier.
The door handle may loosen over time or if you do not install it properly. If this happens,
tighten the set screws on the handles.
Door Handle
Mounting Instructions
1. Remove the handles from the carton
and any other protective packaging.
2. Position the refrigerator handle
end over the upper and lower pre-
installed shoulder bolts (A) that
are fastened into door, ensuring
the holes for the set screws are
facing toward the opposite door.
3. While holding the handle firmly
against door, fasten the furthest
upper and the furthest lower Allen
set screws (B) with the supplied
Allen wrench.
4. Repeat steps 2 and 3 to install
the opposite handle. Ensure the
holes for the set screws are facing
toward the first door.
5. Firmly tighten the inside Allen
set screws.
6. Position the freezer handle end
over the left and right pre-
installed handle shoulder bolts
(A) that are fastened to the door,
ensuring the holes for the set
screws are facing down.
7. While holding the handle firmly
against door, loosely tighten the
far right Allen set screw (B) with
the supplied Allen wrench until
there is no gap between handle
and the door.
8. Still holding the handle firmly to
the door, firmly tighten the far left
Allen set screw (B) with supplied
Allen wrench.
9. Return to the far right Allen set
screw (B) and firmly tighten it with
the supplied Allen wrench.
10. Firmly tighten the inside Allen
set screws.
Mounting the Refrigerator Handles
Mounting the Freezer Handle

NOTE
When tightening the Allen set screws, it is im-
portant to apply force to the longer arm of the
Allen wrench supplied in the handle packaging.
x2
x2
A
A
B
B
x2 x2
x2
x2
A A
A
A
B
B
B
B