Owners Manual

21
AUTOMATIC WATER DISPENSER
1. Before dispensing, please ensure you
enable Water Dispenser on the display
(LEDs above the button are lit).
2. Begin filling the system by pressing and
holding a drinking glass against the
water dispenser paddle.
CAUTION
Hold the door with one hand while
dispensing water to keep the door from
moving and possibly dispensing water on
the floor.
Your refrigerator is equipped with an internal
water dispenser mounted inside the cabinet,
on the left hand fresh food door.

NOTE
If you prefer to keep the internal water
dispenser disabled, use the appliance
control display to disable it. The LEDs will
not illuminate above WATER DISPENSER.
Water dispenser ON Water dispenser OFF
1. Your appliance will arrive with the water
dispenser already activated and ready
to use. To disable the water dispenser
press and hold Water Dispenser for
3 seconds. You have disabled water
dispensing when the LEDs above Water
Dispenser are not lit.
2. Place a cup against the paddle,
and press to dispense water to use
the dispenser.
Priming the water supply system
CAUTION
For the proper dispenser operation, use
water supply pressure between 30 psi and
100 psi. Excessive pressure may cause the
system to malfunction.
Before dispensing water for the first time,
be sure to prime the water supply system.
If you do not flush the system, the first
glasses of water may be discolored or
have an odd flavor.
Using the dispenser after installation
3. Keep the glass in this position until
water comes out of the dispenser. It
may take about 1½ minutes.
4. Continue dispensing water for about
4 minutes to flush the system and
plumbing connections of any impurities
(stop to empty the glass as necessary).