Owners Manual

23
STORAGE FEATURES
CAUTION
To avoid personal injury or property
damage, handle tempered glass shelves
carefully. Shelves may break suddenly if
nicked, scratched, or exposed to sudden
temperature change. Allow the glass shelves
to stabilize to room temperature before
cleaning. Do not wash in the dishwasher.
You can easily adjust shelf positions in the
refrigerator compartments to suit your needs.
The shelves have mounting brackets that
attach to slotted supports at the rear of
each compartment.
IMPORTANT
Note the air seal located at the rear of
the shelf. Shelves located on the left side
should have the air seal mounted on the
far left side. Shelves located on the right
side should have the air seal mounted on
the far right side. This is to ensure there
is no interference with the large air tower
on the back wall of the cabinet. This also
applies to the crisper shelves.
To change the shelf position:
1. Remove all food from the shelf.
2. Lift the front edge up and pull the
shelf out.
Repositioning the Air Seal
For glass shelves:
1. Remove the air seal by pushing the seal
straight back.
2. Position the air seal toward the
outside edge of the shelf to avoid
the air tower when the shelf is pushed
back into place.
3. Install the seal by sliding the open
channel end of the seal onto back edge
of shelf until the seal sits snug on the
back of the shelf and the flap sits at
about a 10° angle from the shelf surface.
To adjust the slide-under shelf:
Push the front half shelf backward toward
the rear of the
cabinet until the
rear half shelf
drops down,
and then gently
continue pushing
the front half
shelf back and
under the rear
half shelf.
Slide-Under Shelf
Shelves
3. Replace by inserting the mounting
bracket hooks into the desired
support slots.
4. Lower the shelf and lock it into position.