Complete Owner's Guide

11
To remove the TempAdapt Drawer
1 Fully open
drawer.
2 Remove
basket
from
drawer.
3 Unsnap
the 4
cable ties by pressing clip sides
together and pushing through
opening.
4 Remove screw and retaining clip and
disconnect the harness.
5 Remove drawer by pressing on the
liner clips and slide rail past clips on
both sides to fully remove drawer
from cabinet.
Press the two
tabs on both
sides to release
the sliders
Cable
Tie
Cable
Clip
NOTE: Do Not Remove or Cut
Cable Ties From Wire Harness
(4) Cable
Ties
Retaining
Clip
Retaining Clip
To Cabinet
Harness
Screw
Installation
Once doors are removed from the unit
using the previous steps in “To remove the
refrigerator doors” in DOOR REMOVAL
section, perform the following steps to
remove and replace the door stop:
1. Turn refrigerator door upside down to
access the door stop located in the
hinge area of the door.
Door Stopper Removal
2. Remove the two screws from the
door stop.
3. Replace door stop with Optional
Door Opening Angle Feature. Insert
the 2 screws and re-tighten to secure
Feature to hinge assembly.
4. Repeat process for opposite
refrigerator door.
5. Re-install doors to the cabinet.