Complete Owner's Guide

15
Connecting Water Supply
Place 7/16" wrench
here. Do not turn.
Place 1/2" wrench
here. Turn
clockwise.
6. Replace the connected tubes into the
clips and lock clips back in place to
keep the tubing in the right position.
7. Turn ON water supply at shutoff valve
and tighten any connections that
leak.
8. Reconnect refrigerator to electrical
power source.
9. Ensure ice maker is turned ON.
10. Purge air from Ice and Water
Dispenser System by operating the
water dispenser for 3-4 minutes. This
will require dispensing several glasses
of water.
To Connect Water Tube to
Household Water Supply
1. Disconnect refrigerator from electrical
power
source.
2. Place end
of water
supply line
into sink
or bucket.
Turn ON
water
supply and
flush supply
line until
water is
clear. Turn
OFF water
supply at shutoff valve.
3. Open the
locking
clips and
grab water
line coming
from the
refrigerator.
Remove
plastic cap
from water
inlet fitting and
discard cap.
4. If using (recommended) stainless
steel braided tubing - the nut and
ferrule are already assembled on the
tubing. Slide compression nut onto
water inlet fitting and finger tighten.
5. Using 1/2” and 7/16” wrenches (one
to hold the household water line nut
and the other to hold the water inlet
fitting nut), tighten a half turn with
wrench. DO NOT over tighten.
To
household
water
supply
To
unit
water valve