User manual

3
CONTENTS
Warnings 2
Use 4
Cleaning the interior 4
Operation 4
Temperature regulation 4
Fresh food refrigeration 4
Freezing fresh food 5
Storage of frozen food 5
Thawing 5
Ice-cube production 5
Movable shelves 6
Positioning the door shelves 6
Hints 7
hints for refrigeration 7
Hints for freezing 7
Hints for storage of frozen food 7
Maintenance 8
Periodic cleaning 8
Periods of no operation 8
Interior light 8
Defrosting 8
Customer service and spare parts 9
Technical information 9
Installation 10
Location 10
Shelf holders 10
Electrical connection 10
Changing the opening direction of the doors 11
Instructions for totally built-in 11
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recyclable.
14
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Fix cover (Hd) on guide (Hb) until it clips into place.
PR167/1
Hd
Hb