Contents For the installer For the user Safety information 3 Description of the appliance 4-5 15 Unpacking 16 - Damages - Use - Positioning - Spray arm - Coarse strainer/microfilter - Fine filter - Detergent dispenser - Rinse aid dispenser - Water softener The control panel Technical specifications Installation - Water inlet - Water drainage - Power supply 6 - How to set the delayed start Information for test centres Setting of the water softener 7 Programme chart 8 Loading and unloading
Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety.
Description of the appliance 4 5 -4-
Description of the appliance Spray arm (1) 4. Close the lid and press until it locks again. It is important to keep all the holes in the spray arm clear. A clogged hole can seriously affect washing efficiency. If the spray arm needs cleaning, unscrew the nut anticlockwise, remove the washer and lift off the spray arm. Clear the holes and shake out any food remnants. Do not fill the rinse aid dispenser with liquid detergent. Electrolux recommends the use of Finish dishwasher detergent and Rinse Aid.
The control panel Indicator and Reset position control lamps On/Off Indicator lamp Delay start Programme button selector Start/Cancel button Programme selector Indicator lamps: Turn the programme selector clockwise or anticlockwise to select the programme and temperature according to the programme chart. Shows current phase of the selected programme.
Setting of the water softener To prevent limescaling on the dishes and to the interior of the dishwasher, the dishes must be washed with soft water. Contact your local Water Authority to find the exact water hardness level for your area. This dishwasher is equipped with a water softener, where tapwater which is harder than 4 °d (german degree) is softened. The water softener has 10 settings: Adjust the water softener according to the table below for the water hardness level for your area.
Programme chart All types of dishes Type of dishes Plates and cooking pots Type of soil: • heavily soiled • normally soiled • dried-on food remnants especially eggwhite and starch • dried-on food remnants All types of dishes Coffee cups, delicate items • normally soiled • lightly soiled • 3) Suitable programme: INTENSIVE 70° C Programme cycle: Pre-wash Washing 2 x rinses Final rinse Drying NORMAL 65° C Pre-wash Washing Rinse Final rinse Drying ENERGY SAVE 55° C 2) Pre-wash Washing Rinse Fina
Loading and unloading the dishwasher How to load the dishes Baskets The illustration shows the dishwasher loaded with six place settings. Your own dishes are not likely to be identical to this load, but if you follow the advices below we are sure you will be pleased with the result. Main basket Cutlery basket The cup shelves can be placed in two different levels. ● Always place glasses, cups and bowls upside down. ● Incline deep dishes (soup plates etc.) so that the water can run off when drying.
Using the appliance Starting the programme Cancelling the drying phase 1. Scrape or rinse off solid food remnants. In case you do not want to wait until the drying phase is completed, you can cancel it. 2. Load the dishwasher. (See the basket and loading). 1. Press and hold in the start button until the programme indicator lamps starts to flash, then release the button. 3. Put the correct amount of detergent into the detergent dispenser and close the dispenser lid. 2. Open the door.
Maintenance and cleaning Cleaning the filters Moving the dishwasher There are two filters, a coarse one and a fine one which should be cleaned after every wash. Lift out these filters which are in the base of the dishwasher and wash under running water. If you have to move the dishwasher (you are moving house, etc): 1. Unplug it. 2. Turn off the water tap. The dishwasher must not be used without the filters. Incorrect repositioning of the filters will produce poor wash results. 3.
Something Not Working Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee. Fault Check The programme will not start.
Service Service and Spare Parts Customer Care Department In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning: For general enquiries concerning your Electrolux appliance or for further information on Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.
Guarantee Conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months from the date of the purchase this ELECTROLUX appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on the rating plate • The appliance has been
Installation instructions Any electrical work required to install this appliance, should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance, should be carried out by a qualified plumber or competent person.
Unpacking Damages If the dishwasher has been damaged during transport, you should immediately notify the company responsible for delivering it. Check that the dishwasher is undamaged. If you discover any damage, faults or that anything is missing, you should notify the dealer immediately. Never leave packaging material in a place where children may play with it.
Installation Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. These features are according to current water technical safety regulations. The dishwasher should be permanently plumbed into a separate cold water supply. The water pressure must be within the limits given in the technical specifications, as it will not function correctly if pressure is outside these specifications.
Installation Power supply The dishwasher is supplied with a lead and electrical plug for connection to a 230 V, 13 A earthed wall socket. Before any work is carried out on the dishwasher, it must be isolated from the electric mains supply, for example by removing the plug from the wall socket. Permanent electrical installation must be carried out by an authorised electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED.
Information for test centres The salt container and rinse aid dispenser shall be filled in accordance with this instruction manual. Before conducting the measurements the dishwasher shall be operated for one or two complete cycles using detergent and a clean load.
www.electrolux.