User manual

Loading your appliance
Before placing dishes in the machine, remove any scraps of
food, to avoid clogging the filters and consequently reducing the
performance.
Do not load very small items which can fall through the
baskets.
Open the door and slide out the baskets to load the dishes.
The lower basket
The lower basket is designed to take saucepans, lids, plates,
salad bowls, cutlery etc.
Serving dishes and large lids should be arranged around the
edge of the basket, ensuring that the upper spray arm can turn
freely.
The two rear rows of prongs on the lower basket can be easily
lowered to allow you to load pots, pans and bowls.
To lower the prongs:
- Slightly pull them upward and let them drop down (see picture).
- To bring them back to the standing position, just pull them up
again.
The cutlery basket
Long bladed knives stored in an upright position are a
potential hazard. These items should only be placed in the
removable knife basket. Take care when loading or
unloading sharp items such as knives.
Removable knife basket
Long and/or sharp items of
cutlery such as carving knives
must be placed horizontally in
the removable knife basket,
which is positioned at the left
side of the upper basket.
Cutlery should be placed in the removable cutlery basket with
the handles facing downwards.
If the handles protrude from the bottom of the basket,
obstructing the lower spray arm, load the cutlery with the
handles facing upwards.
Mix spoons with other cutlery to prevent them from sticking
together.
Silver cutlery tends to go black
if mixed with steel cutlery. Place
it in the cutlery basket separate
from the others.
Arrange spoons, dessert
spoons, knives and other
small items of cutlery in the
racks on both sides of the
cutlery basket.
The upper basket
The upper basket is designed for plates (dessert plates, saucers,
dinner plates of up to 24 cm in diameter), salad bowls, cups and
glasses.
Arrange items so that water
can reach all surfaces.
Glasses with long stems can
be placed upside down in the
cup racks.
The cup rack on the left folds
upwards to increase your
loading flexibility.
Light items (plastic bowls etc.)
should be loaded in the upper
basket and arranged so they do not move.
Before closing the door, ensure that the spray arms can
rotate freely.
Adjusting the height of the upper basket
If washing very large plates (over 27 cm and up to 32 cm in
diameter) you can load them in the lower basket after moving
the upper basket to the higher position.
To move to the higher position proceed as follows:
1. Move the front runnner
stops (A) of the upper
basket outwards and slide
the basket out.
2. Refit the basket in the
higher position and replace
the stops (A) in their original
position.
When the top basket is in the higher position it will only
take plates up to 20 cm in diameter and you will not be able
to use the cup racks.
After loading your machine always close the door, as an
open door can be a hazard.
8
Using your appliance
US69
RC01
UI51
UI12
UI84
UI83
UI09
UI55