User manual

• If the salt indicators is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
9.1 Using the detergent
30
20
A BD
C
20
30
B
A D
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent in the compartment (D).
4. Close the lid. Make sure that the
release button locks into position.
9.2 Using the multi-tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser.
1. Adjust the water softener to the
lowest level.
2. Set the rinse aid dispenser to the
lowest position.
9.3 Setting and starting a
programme
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme
marker is aligned with the
programme you want to set.
• On/off indicator comes on.
• Start indicator starts to flash.
4. Press Start.
• The programme starts and the
indicator of the washing phase is
on.
• On/off indicator and start indicator
are on.
Opening the door while the
appliance operates
If you open the door while a programme
is running, the appliance stops. It may
affect the energy consumption and the
programme duration. When you close
the door, the appliance continues from
the point of interruption.
Cancelling the programme
Press and hold Start and Half Load until
the start indicator starts to flash.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
indicator is on. If you do not
deactivate the appliance within 5 minutes
all indicators goes off. This helps to
decrease energy consumption.
1. To deactivate the appliance, turn the
knob until the programme marker is
aligned with the on/off indicator.
2. Close the water tap.
www.electrolux.com12