User manual

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it

under a close fitting sink unit or a pre-existing top,

providing the dimensions of the recess correspond to

those shown in the picture.

Proceed as follows:

- Remove the machine’s worktop by unscrewing the

two rear retaining screws, pull from the front and

slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling

with the adjustable feet. When inserting the machine,

ensure that the water inlet and drain hoses are not

kinked or squashed.

Levelling

Good levelling is essential for correct closure and

sealing of the door.

When the appliance is correctly levelled, the door will

not catch on the levelling spacers on either side of the

cabinet.

If the door does not close correctly, loosen or tighten

the adjustable feet until the machine is perfectly level.

IN26

820

570 - 600

600

IN05

Hints for test centres

Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse

aid dispenser.

Test standard EN 50242

Reference programme: BIO 50°

Load: 12 standard place settings

Rinse aid selector: position 5

Detergent dosage : 25 g in the dispenser

5 g on the dispenser lid

Arrangement upper basket

Arrangement lower basket

Arrangement cutlery basket